Panasonic KXTS730S User Manual

Quick Guide

Please read the operating instructions for further details.

Connections

1

Interface cable

2

To power outlet (120 V AC, 60 Hz)

Model No. KX-TS730

Interface box

To disconnect the
interface cable, pull
out the cable while
pushing the tabs.

AC adaptor

Fasten the
interface cable.

Note:

L Use only the included Panasonic AC adaptor PQLV10 (9V/850 mA).
L The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel

warm during use.)

L The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet.

Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the
adaptor may cause it to become disconnected.

L The unit will not work during a power failure.

Fasten the
AC adaptor
cord.

Bottom of the
interface box

Hooks

Telephone
line cord

To single-line
telephone jack
(RJ11C)

PQQW14728XA F0305-2055 D

{<} and {>} keys / Function keys

The keys work as the speaker volume keys.
Pressing the keys allows you to scroll through function menu.
Pressing the keys allows you to enter the caller list.

By pressing a function key, you can select the function displayed
directly above it.

PLAYkMENU

Changing the display language

To change the display language from English to Spanish, press {MENU} ({F2} key) {#}
{1} {1} {0} {2}, press {SAVE} ({F3} key), then press {STOP}.

Basic operation

Feature Operation

To make a call Dial the phone number, then press {s}.

To hang up Press {s}.

To adjust the receiver or speaker
volume

To redial the last number dialed Press {s}, then press {REDIAL}.

To make a call using the redial
list

To answer a call Press {s} when hearing rings.

Note:

L At the beginning of a call, both parties should speak alternately. This enables the unit to

adapt to its environment and let both parties speak effectively.

L If the other party has difficulty hearing you, press {<} to decrease the speaker volume.
L Use the unit in a quiet room.

While using the speakerphone, press {<} or {>}
repeatedly.

Press {REDIAL}. Press {<} or {>} repeatedly to
display the desired number. Then, press {s} or
{CALL} ({F3} key).

– 2 –