Panasonic KX-TG1812NZ, KX-TG1811NZ, KX-TG1813NZ User Manual
Operating Instructions
Digital Cordless Phone
KX-TG1811
Charge the batteries for about
7 hours before initial use.
Model No.
KX-TG1811NZ
KX-TG1812NZ
KX-TG1813NZ
Table of Contents
Introduction ............................................................ 2
Preparation ............................................................. 4
Making/Answering Calls ........................................ 9
Phonebook............................................................ 10
Useful Telephone Settings .................................. 11
Caller ID Service ................................................... 14
Multi-unit Operation ............................................. 16
Useful Information................................................ 17
You must subscribe to Caller ID service to use this
feature.
Caller ID
Please read these operating instructions before using the unit and save them for future
reference.
Introduction
Introduction
Thank you for purchasing a new Panasonic digital cordless phone.
For your future reference
Attach or keep original receipt to assist with any repair under warranty.
Serial No. (found on the bottom of the unit)
Date of purchase
Name and address of dealer
Note:
L In the event of problems, you should contact your equipment supplier in the first instance.
Your phone
KX-TG1811 KX-TG1812 KX-TG1813
Note:
L The handsets have been pre-registered for use with their base unit. If not registered, see
page 17.
2
Included accessories
Introduction
No. Accessory items
1 AC adaptor for base unit
Part No. PQLV19AL
2 Telephone line cord 1 1 1
3 Rechargeable batteries AAA size
Part No. HHR-55AAAB or HHR-4EPT
4 Handset cover
5 Charger
Part No. PQLV30018
6 AC adaptor for charger
Part No. PQLV200AL
*1 The handset cover comes attached to the handset.
*2 The AC adaptor for the charger comes connected with the charger.
123
456
*1
*2
Quantity
KX-TG1811 KX-TG1812 KX-TG1813
111
246
123
–12
–12
Note:
L When replacing the batteries, use only 2 rechargeable AAA size nickel metal hydride (Ni-
MH) batteries. We recommend using Panasonic rechargeable batteries (Model No. HHR4EPT).
L We cannot be responsible for any damage to the unit or degradation of performance which
may occur from using non-Panasonic rechargeable batteries.
3
Preparation
Preparation
Important information
General
L Use only the AC adaptor included with this
product, noted on page 3.
L Do not connect the AC adaptor to any AC
outlet other than a standard 220–240 V
AC outlet.
L This product is unable to make calls when:
− The portable handset battery(ies) need
recharging or have failed.
− There is a power failure.
− The key lock feature is turned on.
− The call bar feature is turned on (only
phone numbers stored in the unit as
emergency numbers can be called).
L Do not open the base unit or handset
other than to replace the battery(ies).
L This product should not be used near
emergency/intensive care medical
equipment and should not be used by
people with pacemakers.
L Care should be taken that objects do not
fall onto, and liquids are not spilled into,
the unit. Do not subject this product to
excessive smoke, dust, mechanical
vibration or shock.
L Only the included handset can be used
with the base unit. No other handsets can
be registered or used.
Environment
L Do not use this product near water.
L This product should be kept away from
heat sources such as radiators, cookers,
etc. It should also not be placed in rooms
where the temperature is less than 5 °C or
greater than 40 °C.
L The AC adaptor is used as the main
disconnect device. Ensure that the AC
outlet is installed near the unit and is
easily accessible.
Warning:
L To prevent the risk of electrical shock, do
not expose this product to rain or any
other type of moisture.
L Unplug this unit from power outlets if it
emits smoke, an abnormal smell or makes
unusual noise. These conditions can
cause fire or electric shock. Confirm that
smoke has stopped and contact an
authorised service centre.
Battery caution
L We recommend using the battery(ies)
noted on page 3. Use only rechargeable
battery(ies).
L Do not mix old and new batteries.
L Do not dispose of the battery(ies) in a fire,
as they may explode. Check local waste
management codes for special disposal
instructions.
L Do not open or mutilate the battery(ies).
Released electrolyte from the battery(ies)
is corrosive and may cause burns or injury
to the eyes or skin. The electrolyte may be
toxic if swallowed.
L Exercise care when handling the
battery(ies). Do not allow conductive
materials such as rings, bracelets or keys
to touch the battery(ies), otherwise a short
circuit may cause the battery(ies) and/or
the conductive material to overheat and
cause burns.
L Charge the battery(ies) in accordance
with the information provided in these
operating instructions.
L Only use the included base unit (or
charger) to charge the battery(ies). Do not
tamper with the base unit (or charger).
Failure to follow these instructions may
cause the battery(ies) to swell or explode.
General warnings
L This equipment will be inoperable when
mains power fails.
L When a failure occurs which results in the
4
internal parts becoming accessible,
disconnect the power supply cord
immediately and return this unit to an
authorised service centre.
L Disconnect the telecom connection before
disconnecting the power connection prior
to relocating the equipment, and
reconnect the power first.
L No “111” or other calls can be made from
this device during a mains power failure.
This equipment shall not be set to make
automatic calls to the Telecom “111”
Emergency Service.
L To minimise the possibility of lightning
damage, when you know that a
thunderstorm is coming, we recommend
that you:
− Unplug the telephone line cord from the
phone jack.
− Unplug the AC adaptor from the AC
power outlet.
L The earpiece on the handset is
magnetised and may retain small metallic
objects.
L This equipment has been tested and
found to comply with AS/NZS 3548: 1995
limits for electromagnetic interference.
Any modifications to any part of the
system or to any peripherals may void the
EMC compliance of the system or the
peripherals.
L Not all telephones will respond to
incoming ringing when connected to the
extension socket.
L This equipment may not provide for the
effective hand-over of a call to another
device connected to the same line.
Important notice:
L Under power failure conditions, this
telephone may not operate. Please
ensure that a separate telephone, not
dependent on local power, is available for
emergency use.
Preparation
Connections
Base unit
Hooks
LINE
To telephone
network
(220–240 V,
50 Hz)
Use only the included AC adaptor
and telephone line cord.
Charger (KX-TG1812 and KX-TG1813
only)
Hooks
(220–240 V,
50 Hz)
Use only the included AC adaptor.
Note:
L Never install telephone wiring during a
lightning storm.
L Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight
of the adaptor may cause it to become
disconnected.
L The unit will not work during a power
failure. We recommend connecting a
standard telephone to the same
telephone line or to the same telephone
jack using a BT double adaptor.
L The unit is not designed to be used with
5
Preparation
rotary (pulse dialling) services.
If you subscribe to an ADSL service
L Please attach a noise filter (contact your
ADSL service provider) to the telephone
line between the base unit and the
telephone line jack in the event of the
following:
− Noise is heard during conversations.
− Caller ID features (page 14) do not
function properly.
Telephone
line cord
Noise filter
(For ADSL users)
Location
For maximum distance and noise-free
operation, place your base unit:
− Away from electrical appliances such as
TVs, radios, personal computers or other
phones.
− In a convenient, high and central location.
Battery installation
Important:
L Wipe the battery ends (S, T) with a dry
cloth.
L Install the batteries without touching the
battery ends (S, T) or the unit contacts.
Insert the batteries negative (T) terminal
first. Close the handset cover.
Note:
L Use only the included rechargeable
batteries (page 3, 4).
Turning the power on/off
Power on
L Press {ih} for about 1 second.
Power off
L Press {ih} for about 2 seconds.
Battery charge
Place the handset on the base unit or
charger for about 7 hours before initial
use.
Battery strength
Battery icon Battery strength
054 Fully charged.
5 High
6 Medium
7 Low
074 Needs to be charged.
Panasonic Ni-MH battery performance
Operation Operating time
In continuous use 10 hours max.
In continuous standby
mode
120 hours max.
6
Loading...