Panasonic KX-PRLA20 User Manual
Installation Manual
Additional Digital Cordless Handset
Model No. KX-PRLA20
Thank you for purchasing a Panasonic product.
This unit is an additional handset compatible with the following series of
Panasonic Digital Cordless Phone:
- KX-PRL262/KX-PRD262
(The corresponding models are subject to change without notice.)
You must register this handset with your base unit before it can be used. This
installation manual describes only the steps needed to register and begin using
the
handset. Please read the base unit’s operating instructions for further details.
Please read this installation manual before using the unit and save it for future
reference.
For assistance, visit our Web site: http://www.panasonic.com/help
for customers in the U.S.A. or Puerto Rico.
Printed in Malaysia
PNQX6434ZA
CC1213WK0
1
2
1
Installation
Accessory information
Supplied accessories
Accessory item/Order number Quantity
Charger/PNLC1054ZB 1
AC adaptor/PNLV233Z 1
Rechargeable batteries/HHR-4DPA 2
Handset cover
*1 The handset cover comes attached to the handset.
N
ote:
R Please read the base unit’s operating instructions for additional/replacement
accessories.
1
*
/PNYNTGHA20BR
1
Setting up
Connections
Connect the AC adaptor plug to the charger until you hear a click.
Connect the AC adaptor to the power outlet.
Note:
se only the supplied Panasonic AC adaptor PNLV233.
R U
R The AC adaptor must remain connected at all times. (It is normal for the adaptor
to feel warm during use.)
Battery installation/Battery charging
I
mportant:
R Use the supplied rechargeable batteries. For replacement, we recommend using
the Panasonic rechargeable batteries noted on page 2.
R USE ONLY rechargeable Ni-MH batteries AAA (R03) size (
For assistance, please visit http://www.panasonic.com/help
2
).
2
1
2
Installation
R D
o NOT use Alkaline/Manganese/Ni-Cd batteries.
R Confirm correct polarities (
C
harge for about 7 hours.
R Confirm “Charging” is displayed (
R When the batteries are fully charged, “Fully charged” is displayed.
Note:
f the batteries are fully charged, but the operating time seems to be shorter,
R I
clean the battery ends (
harge again.
c
, ).
).
, ) and the charge contacts with a dry cloth and
Registering a handset to a base unit
1 Base unit:
Press and hold M N
R If all registered handsets start ringing, press M
this step.
for about 5 seconds.
N
again to stop, then repeat
2 Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
N
ote:
R If an error tone sounds, or if
he base unit’s operating instructions.
t
is displayed.
is displayed, register the handset according to
Display language
ENUN (right soft key) #110
1 MM
2 MbN: Select the desired setting. a MSAVEN a MOFFN
For assistance, please visit http://www.panasonic.com/help
3
Installation
For your safety
To prevent severe injury and loss of life/property, read this section carefully before
using the product to ensure proper and safe operation of your product.
WARNING
Power connection
ompletely insert the AC adaptor/power plug into the power outlet. Failure to do
R C
so may cause electric shock and/or excessive heat resulting in a fire.
R Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it
from the power outlet, then wiping with a dry cloth. Accumulated dust may cause
an insulation defect from moisture, etc. resulting in a fire.
R Unplug the product from power outlets if it emits smoke, an abnormal smell, or
makes an unusual noise. These conditions can cause fire or electric shock.
Confirm that smoke has stopped emitting and contact us at http://
www.panasonic.com/contactinfo
Installation
R To prevent the risk of fire or electrical shock, do not expose the product to rain
or any type of moisture.
R Do not place or use this product near automatically controlled devices such as
automatic doors and fire alarms. Radio waves emitted from this product may
cause such devices to malfunction resulting in an accident.
CAUTION
Installation and location
he AC adaptor is used as the main disconnect device. Ensure that the AC
R T
outlet is installed near the product and is easily accessible.
Battery
e recommend using the supplied batteries or additional/replacement batteries
R W
noted on page 2 for replacement battery information. USE ONLY rechargeable
Ni-MH batteries AAA (R03) size.
R Do not mix old and new batteries.
R Do not open or mutilate the batteries. Released electrolyte from the batteries is
corrosive and may cause burns or injury to the eyes or skin. The electrolyte is
toxic and may be harmful if swallowed.
R Exercise care when handling the batteries. Do not allow conductive materials
such as rings, bracelets, or keys to touch the batteries, otherwise a short circuit
For assistance, please visit http://www.panasonic.com/help
4
Loading...