Panasonic KX-HNC301 Operation Manual
Installation Manual
Baby Monitor
Additional camera
Model No. KX-HNC301
Thank you for purchasing a Panasonic product.
This unit is an additional camera compatible with the following
series of Panasonic Baby Monitor:
– KX-HN3001/KX-HN3051
You must register this camera with your baby monitor before
it can be used. This installation manual describes only the steps
needed to register and begin using the camera. Please read the
baby monitor’s operating instructions for further details.
Please read this installation manual before using the unit and save it for
future reference.
For U.S.A. users
For assistance, please contact us at 1-800-272-7033 or visit our Web
site: http://shop.panasonic.com/support for customers in the U.S.A.
For Canada users
For assistance, please visit our support page on:
www.panasonic.ca/english/support
www.panasonic.ca/french/support
(Camera Model No. KX-HNC300)
FrançaisEspañol
English
Introduction
Accessory information
Supplied accessories
No. Accessory item/Part number Qty.
*
A
AC adaptor
B
Wall mounting adaptor
A B
For U.S.A. users:
1 PNWYAC300W00 (for U.S.A. users only)
*
*2 PNWYAC300W01 (for U.S.A. users only)
Other information
R D
esign and specifications are subject to change without notice.
R The illustrations in these instructions may vary slightly from the actual
product.
1
*
2
1
1
2
2
1
Installation
Connections
Insert the AC adaptor plug firmly into the DC jack.
Connect the AC adaptor to the power outlet.
Note:
se only the supplied AC adaptor S006AKU0500100.
R U
R The camera unit can be placed on a flat surface. Make sure to choose
a stable location.
R The camera can also be mounted on the wall (page 10).
Note about power connections
C adaptor connection
A
R The AC adaptor must remain connected at all times. (It is normal for
the adaptor to feel warm during use.)
R The AC adaptor should be connected to a vertically oriented or
floor-mounted AC outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of the adaptor may cause it
to become disconnected.
3
1
2
2
1
Installation
Registering a camera unit
ou must register the camera unit to your monitor unit before it can be
Y
used.
1 Monitor unit:
MMENUN a MbN: “Camera Management” a MOKN a MbN: “Add
Camera” a MOKN
R An operation guide is displayed. Press MOKN to continue.
R Complete the following step within 90 seconds.
2 Camera unit:
Press and hold M
blinking.
M N
LED indicator
Note:
message is displayed on the monitor unit to show if the registration
R A
was successful or not, and a beep sounds.
for 3 seconds until the LED indicator starts
N
(Pairing)
LED indicator
Y
ou can use the LED indicator to confirm the camera unit’s status.
LED indicator Status
Off No power
Green, lit Normal operation
Green, blinking slowly Registration mode
Green, blinking quickly Device malfunction
4
Important Information
Graphical symbols for use on equipment
nd their descriptions
a
Symbol Explanation Symbol Explanation
Alternating current
A.C.)
(
Direct current (D.C.)
For indoor use only Stand-by (power)
Class P
(equipment in which
protection against
electric shock relies on
Double Insulation or
Reinforced Insulation)
equipment
About this system
R This system is an auxiliary system; it is not designed to provide complete
protection from property loss. Panasonic will not be held responsible in the
event that property loss occurs while this system is in operation.
R This product should not be used as substitute for a medical or caregiver’s
supervision. It is the caregiver’s responsibility to stay close enough to handle
any eventua
R The system’s wireless features are subject to interference, therefore
functionality in all situations cannot be guaranteed.
Panasonic will not be held responsible for injury or damage to property that
occurs in the event of wireless communication error or failure.
R If a power failure occurs or the power is disconnected, the temperature will not
be accurate for up to an hour.
lity.
5
Important Information
For your safety
o prevent severe injury and loss of life/property, read this section
T
carefully before using the product to ensure proper and safe operation of
your product.
WARNING
Power connection
R C
ompletely insert the AC adaptor/power plug into the power outlet.
Failure to do so may cause electric shock and/or excessive heat
resulting in a fire.
R Regularly remove any dust, etc. from the AC adaptor/power plug by
pulling it from the power outlet, then wiping with a dry cloth.
Accumulated dust may cause an insulation defect from moisture, etc.
resulting in a fire.
R Unplug the product from power outlets if it emits smoke, an abnormal
smell, or makes an unusual noise. These conditions can cause fire or
electric shock. Confirm that smoke has stopped emitting and contact
us.
For U.S.A. users
http://shop.panasonic.com/support
For Canada users
www.panasonic.ca/english/support
www.panasonic.ca/french/support
R Unplug from power outlets and never touch the inside of the product if
its casing has been broken open. Danger of electric shock exists.
R Never touch the plug with wet hands. Danger of electric shock exists.
Installation
R T
o prevent the risk of fire or electrical shock, do not expose the
product to rain or any type of moisture.
R Do not place or use this product near automatically controlled devices
such as automatic doors and fire alarms. Radio waves emitted from
6
Important Information
this product may cause such devices to malfunction resulting in an
accident.
R WARNING:
Strangulation Hazard: Children have STRANGLED in cords.
Keep this cord out of the reach of children (more than 1 m (3 feet)
away).
R Do not allow the AC adaptor to be excessively pulled, bent or placed
under heavy objects.
R Keep small parts, such as screws, out of the reach of children. There
is a risk of swallowing. In the event they are swallowed, seek medical
advice immediately.
Operating safeguards
nplug the product from power outlets before cleaning. Do not use
R U
liquid or aerosol cleaners.
R Do not disassemble the product.
R Never put metal objects inside the product. If metal objects enter the
product, turn off the circuit breaker and contact an authorized service
center.
Medical
onsult the manufacturer of any personal medical devices, such as
R C
pacemakers or hearing aids, to determine if they are adequately
shielded from external RF (radio frequency) energy. DECT features
7
Important Information
operate between 1.92 GHz and 1.93 GHz with a peak transmission
power of 115 mW (max.).
R Do not use the product in health care facilities if any regulations
posted in the area instruct you not to do so. Hospitals or health care
facilities may be using equipment that could be sensitive to external
RF energy.
CAUTION
Installation and location
R Never install wiring during a lightning storm.
R The AC adaptor is used as the main disconnect device. Ensure that the AC
outlet is installed near the product and is easily accessible.
R Mount the product on the stable location where the camera unit can be
adequately supported when installing.
R Do not mount the product on soft material. It may fall down, break or cause
injury.
not mount the product on the following materials: gypsum board, ALC
R Do
(autoclaved lightweight cellular concrete), concrete block, plywood less than
25 mm (1 inch) thick, etc.
Preventing accidents and injuries
o not put your ear(s) near the speaker, as loud sounds emitted from
R D
the speaker may cause hearing impairment.
Important safety instructions
W
hen using your product, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
1. Do not use this product near water for example, near a bathtub,
washbowl, kitchen sink, or laundry tub, in a wet basement or near a
swimming pool.
2. Use only the power cord indicated in this manual.
8
Loading...