Panasonic ET-MDNHM10 User Manual
S P E C F I L E
Interface Board for HDMI 2 input
Description
This is an input board for mounting to the PT-RQ13K 3-chip DLP™ projector, and it allows input of two HDMI signal systems.
* This unit does not operate as a stand-alone unit. Use it by mounting to the PT-RQ13K 3-chip DLP™ projector ( sold separately ).
* It is recommended that installation and removal of the interface board for the main projector unit should be carried out by a qualified
technician. Please contact the place of purchase.
Specifications
Compatible slot : SLOT NX specifications
Compatible frequencies : • Resolution
Dimensions ( W × H × D ) : 151 × 38.5 × 142 mm ( 5-15/16˝ × 1-17/32˝ × 5-19/32˝ )
Weight : Approx. 350 g*
Applicable projector : PT-RQ13K (As of November 2015)
Dimensions
( Specifications and appearance are subject to change for improvement without notice. )
HDMI 19-pin ×2Terminals :
[Digital signal] HDCP 2.2 compatible,Deep color compliant, for single link only
Movie signal resolution : 480i*
Still picture signal resolution : 640 x 400~2,560 x 1,600( non-interlace )
• Dot clock frequency : 25 MHz~594 MHz
2
( 12.3 oz*2 )
1
/576i*1~ 4,096 x 2,160
*1 Pixel-Repetition signal (dot clock frequency 27.0 MHz) only.
*2 Average value. May differ depending on models.
E T-MDNHM10
142(5-19/32)
22(7/8) 120(4-23/32)
38.5(1-17/32)
NOTE: This illustration is not drawn to scale.
151.1(5-15/16)
unit : mm (inch)
As of November 2015
SFL15A018
1/1
Loading...