Panasonic ET-MD77SD3 User Manual

ET-MD77SD3

HD-SDI/SD-SDI Board for DLP™ Projector

S P E C F I L E

As of December 2006

204

(8-1/32˝)

21432

(8-7/16˝)(1-1/4˝)

Specifications

Power supply: Provided from the DLP™ projector Power consumption: Projector power consumption increases approximately 10 W Terminals: Serial input: BNC x 1

4:2:2 digital serial component signal: SMPTE 259M compliant, 480i, 576i HD digital serial component signal: SMPTE 292M compiant,

720/60p, 720/50p, 1035/60i, 1080/60i, 1080/50i,

1080/25p, 1080/24p, 1080/24sF, 1080/30p Serial output: BNC x 1, active through LAN: RJ-45 x 1, 10Base-T/100Base-TX for network connection

Dimensions (W x H x D): 204 x 32 x 214 mm (8-1/32ý x 1-1/4ý x 8-7/16ý) Weight: 290 g (10.2 lbs.) Operating temperature: 0°C – 40°C Operating humidity: 10% – 80% (no condensation)

NOTE: Use connection cables of 5CFB or higher (ex. 5CFB, 7CFB, 5CFTX, etc.).

720/50p signals can be input only when this unit is used with the PT-DW10000, PT-D10000, PT-DW7000 or PT-D7700.

Weights and dimensions shown are approximate.

Specifications subject to change without notice.

DLP and DLP logo are trademarks of Texas Instruments.

This board is designed for use with the DLP™ projectors. It enables the input of a HD digital serial component signal (SMPTE292M-compliant). Remote control of the projector is also possible from an external computer connected via LAN.

NOTE: Please use the module only on the specified Panasonic DLP™ projector.

Dimensions

unit: mm

(Dimensions given in inches are approximate.)

Note: This illustration is not drawn to scale.