S P E C F I L E
HD/SD-SDI Interface Board
ET-MD16SD1
escriptionD
This board is designed for use with a Panasonic’s applicable projector. It enables the input of a HD-SDI (SMPTE 292M-compliant) and SD-SDI (SMPTE 259M-C).
Specifications |
|
Power supply: |
Provided from the projector |
Terminals: |
|
SERIAL IN (SDI IN 1/2) |
BNC × 2 |
|
SD-SDI signal (YCBCR 4:2:2 10-bit), |
|
SMPTE 259M compliant: 480i, 576i |
|
Single-link HD-SDI signal (YPBPR 4:2:2 10-bit), |
|
SMPTE 292M compliant: 720/60p, 720/50p, 1035/60i, 1080/50i, 1080/60i, |
|
1080/25p, 1080/25sF, 1080/24p, 1080/24sF, 1080/30p, 1080/30sF |
SERIAL OUT (SDI OUT) |
BNC × 1, active through |
Dimensions (W × H × D): |
187 × 30 × 110 mm (7-3/8˝ × 1-3/16˝ × 4-11/32˝ ) |
Weight: |
Approx. 160 g* (3.3 oz*) |
Operating temperature: |
0°–40°C (32°–104°F) |
Operating humidity: |
10%–80% (no condensation) |
Applicable projector: |
PT-EX16K/EX12K |
* Average value. May differ depending on models. NOTE: Use connection cables of 5CFB or higher (ex. 5CFB, 7CFB, 5CFTX, etc.).
Dimensions
110 ( 4 -11/ 32 )
SDI IN 1 SDI IN 2 SDI OUT
3 0 (1- 3 /16 )
187 ( 7- 3 / 8 )
unit : mm (inch) NOTE: This illustration is not drawn to scale.
Weights and dimensions shown are approximate. Specifications subject to change without notice.
As of Janauary 2012 |
1 / 1 |
|
|
|
|
SFL11A017-1