Panasonic ET-DFD75 User Manual

1
ET-DFD75
Dual Stacking Mount Bracket
S P E C F I L E
Description
This mount bracket is to be used when stacking two DLP™-based projectors.
Specifications
Weights and dimensions shown are approximate. Specifications subject to change without notice.
Digital Light Processing and DLP are trademarks of Texas Instruments.
Base frame . . . . . . . . . . . . . . . . . . . . .1
Guard frame . . . . . . . . . . . . . . . . . . . .2
Cable guide fitting . . . . . . . . . . . . . . . .2
Washer-fitted screws (M4 x 8) . . . . . .20
Spacers . . . . . . . . . . . . . . . . . . . . . . .10
Set mounting base A . . . . . . . . . . . . . .1
Set mounting base B . . . . . . . . . . . . . .1
Screws (M6) . . . . . . . . . . . . . . . . . . .10
Hex nuts (M8) . . . . . . . . . . . . . . . . . . .8
Flat washers (M8) . . . . . . . . . . . . . . . .8
Spring washers (M8) . . . . . . . . . . . . . .8
Allen hex socket bolts (M8) . . . . . . . . .4
Mounting nuts A (M8) . . . . . . . . . . . . . .4
Adjustment bolts (M8) . . . . . . . . . . . . .4
Flat washers A . . . . . . . . . . . . . . . . . .4
Flat washers B . . . . . . . . . . . . . . . . . .4
Mounting nuts B (M8) . . . . . . . . . . . . . .4
Flat washers (M4) . . . . . . . . . . . . . . . .4
Spring washers (M4) . . . . . . . . . . . . . .4
Hex nuts (M4) . . . . . . . . . . . . . . . . . . .4
Caution:
Mounting should be done by a qualified technician. Make sure that the mounting (ceiling) area has sufficient strength. Read the enclosed mounting instructions thoroughly before starting.
As of September 2004
Dimensions
unit: mm (inch)
(Dimensions given in inches are approximate.) Note: This illustration is not drawn to scale.
Parts
The ET-DFD75 with two DLP™-based projector mounted.
2.32( 98)
7.91( 00)
650 (25.6˝)
78.2(3) 8.62( 08)
Loading...