Palm III Getting Started

READ THIS FIRST

Getting Started

Connected Organizers



Get to know your new Palm III™organizer

IR Port

Exchange data and applications with
any Palm Computing®organizer that’s
also equipped with an infrared port.

Applications Launcher

Tap the Applications icon to see all
your Palm™applications.

Graffiti®Writing Area

Use Graffiti®writing software to enter
text and numbers into your Palm III
organizer.

Power Button/Backlight Control

Press to turn your Palm III organizer
on and off. Hold for a few seconds to
activate the screen backlight.

Cradle and HotSync®Button

Attach the cradle to your computer
and press the HotSync®button to
exchange data back and forth
between your Palm III organizer
and computer.

Date Book Address Book

Contrast Control

™

Stylus

Scroll Button

To Do List Memo Pad

Applications Buttons

Press buttons to immediately
access your main applications.

Set up your Palm III™organizer

1.

Install AAA batteries as shown.

Push up on the stylus
to remove it.

2.

Configure your Palm III™organizer.

• Remove the protective screen film.

• Follow the instructions onscreen to

set up your organizer.

Hints: If your organizer does not turn on, try these steps:

• Adjust the contrast control.

• Press the power button. Your organizer turns off automatically when it is
not in use.

• Make sure the batteries are fresh and properly installed.

• Some models include a reset tip inside the stylus. Simply unscrew the tip
of the stylus, or use an unfolded paperclip, and gently press the reset
button on the back of your organizer.

• If your organizer still does not turn on, hold down the power button while
pressing the reset button and then release it.