Page 1
INSTRUCTION Manual DC850R - 3/6/2018
PAASCHE
DC850R Pro Series
Air Compressor
3/4 HP, 120 Volts, 60 Hz,
Max Operating Pressure 100 PSI.
Weight: 36.3 lbs (16.5 kg)
Features:
Portable & Lightweight
•
•
Ultra Quiet 58 Decibels
Thermally Protected
•
•
Steady Air Flow
•
Regulator
Auto Stop and Start
•
1/4” NPT Fittings
•
•
Dual Quick Connects
WARNING: When a flammable liquid is sprayed, there
may be danger of fire or explosion especially in a closed
room. Keep compressor at least 20 feet away from
areas where hazardous concentrations of flammable
vapors are likely to occur. Disconnect power before
servicing.
ATTENTION: Lorsqu'un liquide inflammable est pulverise,
il peut y avoir danger d'incendie ou d'explosion,
specialement dans une piece fermee; garder le
compresseur a au moins 20 pieds des endroits ou des
concentrations dangereuses de vapeurs inflammables
sont susceptibles de se produire. Debrancher avant toute
maintenance.
Compressor Specs:
• Dual Piston / Oil Free
• 3/4 HP
• 110-120 Volt /60HZ 5.5 Amps
• 100 Max Pressure
• 2.40 CFM @ 40psi
1.50 CFM @ 90 psi
• Tank Size: 6L =1.585 Gallons
• 36 lbs (16.3kg)
Carrying Handle
•
1)
Before operating Compressor, Install Muffler on compressor head
"Hand tight" with drain hose facing down.
Apply PTFE pipe tape (Included) to male thread of Quick connect
2)
(Included). Thread onto 1/4"Airbrush hose end. Attach airbrush to
1/8" hose end.
Plug compressor into grounded outlet, pull up on red button on black box.
3)
When compressor stops, press trigger on airbrush and hold down while
4)
turning large red air regulator clockwise to increase air, or counterclockwise to
decrease air. When gauge reaches desired pressure release trigger.
• Dim: 17”L x 14”W x 13”H
• 5 Foot Electric Cord
Operation Instructions:
5)
Turn off compressor after use and loosen drain valve at bottom of
compressor to empty out any standing water in tank .
Page 2
GENERAL & SAFETY INFORMATION
GENERAL INFORMATION
The maximum pressure of the compressor is 0-100 PSI . The maximum operating pressure while spraying will vary
depending on size of fluid tip, needle and aircap.
THERMAL PROTECTOR
The motor of this compressor has
a thermal overload protector. If the
motor should overheat, the
overload protector will shut off the
motor. If this should occur, unplug
the compressor and allow the motor
to cool (approx. 5 minutes) and
restart compressor.
SEALING OF AIR HOSE
When attaching the female pipe
thread fitting from your air hose to
the compressor use PTFE pipe
thread tape (Included) on the Male
quick connect. Failure to do so may
cause an air leak and your
compressor will not shut off as it
should. NOTE: This unit does not
require any lubricants or oil. Applying
oil to any part could result in damage
to the compressor. All bearings,
including those in the motor, are
grease packed.
Included male
quick connects
Pull-ON.....Push-OFF
Air outlet gauge
Muffler
Air
Regulator
Tank pressure
gauge
AUTOMATIC SHUT-OFF FEATURE
This compressor has a built-in
pressure switch that automatically
shuts-off the compressor when the
tank is full. It will immediately start
again as soon as the tank reaches the
pre-set psi.
WARNINGS
• Only use 110-120 volt, 60 cycle power supply for this compressor.
• Before plugging in check to make sure compressor is in good condition.
• Only operate compressor in accordance with current safety regulations.
• Keep working area clean and uncluttered and make sure area is well ventilated. Never operate the compressor in the presence of
flammable liquids or gases.
• Compressor air can produce dust, dirt and loose particles it comes in contact with. To prevent possible injury always wear safety
goggles or glasses. Never point any nozzle or spray toward a person.
•
The air compressor is powered by electricity. Like any electric device, if not used properly it can cause electric shock.
• Keep out of reach of children.
QM-2/QM-4 manifolds. For
1)
Suggested Accessories:
Tank
Moisture
drain valve
multiple hose hook ups.
2)
Hose adapter. If your hose has
a 1/8” NPT fitting get the HF-592.
For the opposite get HF-116.
A-194 Airbrush Holder
3)
AC-7 Airbrush Cleaning Brushes
4)
Paasche Airbrush Company
4311 North Normandy Avenue
Chicago, IL 60634-1395
Phone: 773-867-9191 • Fax: 773-867-9198 Website:
paascheairbrush.com
E-Mail: info@paascheairbrush.com
This compressor is
Manufactured in China for Paasche
CE Listed
Loading...