Ozito PXCGSS-018 Instruction Manual

CORDLESS GRASS
TRIMMER & SHEAR

INSTRUCTION MANUAL

SPECIFICATIONS

Voltage: 18V

No Load Speed: 1,200/min

Hedge Trimmer: 200mm Blade

Grass Shear: 100mm Blade

Max. Cutting Cap.: 8mm

Weight: 1.0kg

PXCGSS-018

WHAT’S IN THE BOX

Cordless Grass Trimmer /
Shear

Hedge Trimmer Blade

ozito.com.au

Grass Shear Blade

Blade Covers

Battery & Charger sold
separately

ONLINE MANUAL

Scan this QR Code with your mobile
device to take you to the online manual.

KNOW YOUR PRODUCT

1. CHANGING BLADES

SETUP & PREPARATION

1. Slide the back of the
blade base into the
recess in the housing.

Inserting the Blade Base

Remove the Blade Base

WARNING! ENSURE THE TOOL IS SWITCHED

OFF AND BATTERY DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING STEPS.
WEAR GLOVES, BLADES ARE SHARP.

ACCESSORIES

1 2 3 4 5

6

7

8

1. Base Release Button

2. Removable Base

3. Safety Switch

4. On/Off Trigger

5. Sure Grip Handle

6. Battery Seating

CORDLESS TRIMMER/SHEAR

7. Hedge Trimmer Blade

8. Grass Shear Blade

9. Blade Covers

2. Push the front of the
blade base into the
housing until it clicks
into place.

1. Press and hold the base
release button.

2. Remove the base by
lifting from the front and
then sliding out.

9

Note: Ensure the base is supported by hand when the release button is

pressed to prevent it falling unexpectedly.

2. BATTERY & CHARGING (sold separately)

Charger LED Indicator

LED Indicator Situation

GREEN (Flashing) Stand By (no battery pack is inserted)

RED (Flashing) Battery is charging (low charge)

RED (Illuminated) Battery is charging (mid charge)

GREEN (Illuminated) Battery is fully charged

BOTH(Illuminated) Battery pack is too hot or too cold (charging will begin

automatically when battery reaches correct charging
temperature).

BOTH (Flashing) Defective battery. Never charge a defective battery

pack!
Remove battery pack from charger.

CAUTION: THE CHARGER FOR THIS PRODUCT

SHOULD BE PROTECTED BY A RESIDUAL CURRENT
DEVICE (RATED AT 30mA OR LESS).

The purchased battery will be shipped in a low charge condition, and requires charging
prior to use. Allow several cycles of charging and discharging (through use of the tool)
for the battery to reach its optimum performance / runtime.

1. Connect the charger into a mains power outlet.

4. The charger LED will illuminate
red signifying that the battery is
charging.

3. With the charger sitting on a at

surface, align the raised ribs on
the battery with the recess in the
charger and slide onto the charger
ensuring a rm connection.

2. The charger LED will ash green
showing power is being supplied
to the charger.

5. The charger LED will illuminate
green once the battery is fully
charged.

Charging your lithium ion battery - Fast Charger

Battery Charge Indicator

The purchased battery is equipped with a
battery charge indicator to show the state of
the battery charge.

Press the charge indicator button and look to
see which LED lights.

Battery requires
immediate charging

Low state of charge, requires charging soon.

Mid state of charge

Full state of charge.

Note: The battery needs to be removed from the tool to check the state of charge.

1. Connect the charger into a mains power outlet.

4. The charger LED will illuminate red signifying that the battery is
charging.

3. With the battery sitting on a at

surface, align the raised ribs on the
battery with the recess in the charger
and slide onto the battery ensuring a
rm connection.

2. The charger LED will ash green

showing power is being supplied
to the charger.

5. When removing the charger from the
battery, rst press the battery release
tab, then slide the charger from its
position.

Charging your lithium ion battery - Eco Charger

Charger LED Indicator

LED Indicator Situation

GREEN (Flashing) Stand By (no battery pack is inserted)

RED (Illuminated) Battery is charging (low charge)

GREEN (Illuminated) Battery is fully charged

RED (Flashing) Battery or Charger fault

RED & GREEN (Flashing) Battery pack is too hot or too cold (remove battery from

charger and store at room temperature 20ºC. Insert
battery again when at correct charging temperature). If
this happens again, the battery is defective and needs
to be replaced.