Ozito AGG-042K Operating Instructions Manual

ANGLE GRINDER KIT

1200W MODEL NO. AGG-042K

Always W

ear Eye, Face & Ear Pr

otection

www

.ozito.com.au

OPERATING INSTRUCTIONS

0208

SPECIFICATIONS – MODEL NO. AGG-042K

3

Motor: 1200W
Input: 230V ~ 50Hz
No load speed: 10,500 rpm
Disc size: 125mm (5”)
Disc bore size: 22mm
Spindle: M14

Features: Soft grip

Three position side handle
Safety lock off switch

1. Spindle lock

2. Metal gear casing

3. Soft grip rear handle

4. Safety lock of

f switch

5. Three position side handle

6. Safety guard

7. Abrasive disc

5

6

7

1

2

3

4

INTRODUCTION

4

SAFETY INSTRUCTIONS

ELECTRICAL SAFETY

Warning! When using mains-powered equipment, basic safety precautions,

including the following, should always be followed to reduce risk of fire,
electric shock, personal injury and material damage.

Read and understand the manual prior to operating this tool.

Save these instructions and other documents supplied with this tool for future reference.

The electric motor has been designed for 230V and 240V only. Always check that
the power supply corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for
Australia and New Zealand.

This tool is double insulated in accordance with AS/NZS 3100:2002;
therefore no earth wire is required.

If the supply cord is damaged, it must be replaced by an electrician or a power tool
repairer in order to avoid a hazard.

Note: Double insulation does not take the place of normal safety precautions when
operating this tool. The insulation system is for added protection against injury
resulting from a possible electrical insulation failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool.
Before use, inspect the extension lead for signs of damage, wear and ageing.
Replace the extension lead if damaged or defective. When using an extension lead
on a r

eel, always unwind the lead completely. Use of an extension lead not suitable
for the power input of the tool or which is damaged or defective may result in a
risk of fire and electric shock.

Congratulations on purchasing an Ozito Angle Grinder
Kit. We aim to provide quality tools at an affordable price.
We hope you will enjoy using this tool for many years.

Your Ozito Angle Grinder Kit AGG-042K has been
designed to grind and cut all types of material and
is intended for DIY use only.