Ovislink AirLive ePhone-1000 User Manual

User’s manual

AirLive ePhone

–

1000

VOIP IP Phone

- 2 -

Safety Instructions

Safety Instructions Do not attempt to service the product yourself. Any
servicing of this product should be referred to qualified service personal.

To avoid electric shock, do not put your finger, pin, wire, or any other metal
objects into vents and gaps.

To avoid accidental fire or electric shock, do not twist power cord or place it
under heavy objects.

The product should be connected to a power supply of the type described in
the operating instructions or as marked on the product.

To avoid hazard to children, dispose of the product’s plastic packaging
carefully.

Please read all the instructions before using this product.

- 3 -

Safety Notices

These are the safety considerations for using the AirLive ePhone-1000 . Read these notices before
installing or using the phone.

Warning This warning symbol means danger. You are in a situation that could cause bodily injury.
Before you work on any equipment, be aware of the hazards involved with electrical circuitry and
be familiar with standard practices for preventing accidents. To see translations of the warnings that
appear in this publication, refer to the Regulatory Compliance and Safety Information document
that accompanie d this device.

Warning Read the installation instructions before you connect the syste m to i ts p ow e r so urc e.

Warning Ultimate disposal of this product should be handled according to all national laws and

regulations.

Warning Do not work on the system or connect or disconnect cables during periods of lightning
activity.

Warning To avoid electric shock, do not connect safety extra low voltage (SELV) circuits to
telephone network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports use RJ-45 connectors. Use caution when
connecting cables.

The next warning applies when you use an external power supply.

- 4 -

Warning This product relies on the building's installation for short-circuit (over current) protection.

Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A
international) is used on the phase conductors (all current-carrying conductors).

Warning The device is designed to work with TN power systems.

- 5 -

Table of Contents

SAFETY NOTICES 3

TABLE OF CONTENTS 5

PRODUCT SPECIFICATIONS 7

PACKAGE CONTENTS 8

AIRLIVE EPHONE-1000 FUNCTIONS 9

Front Panel ................................................................................................................................................ 9

Rear and Back Panel ...................................................... ........................................................................ 10

Function Keys .........................................................................................................................................11

HARDWARE INSTALLATION 12

CONFIGURING THE AIRLIVE EPHONE-1000 WITH THE KEYPAD 13

Configuring Network Settings......... ...... .. ... ..... ... ... .. ...... .. ... ..... ... ... ..... ... .. ...... .. ... ..... ... ... ..... ... .. .. . ........... 14

Configuring for DHCP..........................................................................................................................................14

Configuring for Static IP.......................................................................................................................................14

Configuring for PPPoE ........................................................................................................................................15

Protocol Settings .................................................................................................................................... 16

Audio Settings.........................................................................................................................................18

Other Settings ......................................................................................................................................... 19

Speed Dial Settings ................................................................................................................................ 20

Revert Back to Factory Default .......................................... ..................................................... .. ............ 21

Storing Settings ......................................................................................................................................22

- 6 -

Editing Settings............................... ........................................................ ................................................23

Saving Settings............................ ..... ... ..... ... ... ..... ... ..... ... .. ...... .. ...... .. ... ..... ... ..... ... ... ..... ... . ....................... 24

Exit Settings ............................................................................................................................................24

WEB CONFIGURATION 25

NETWORK PARAMETERS 27

PROTOCOL PARAMETERS 28

PHONE PARAMETERS 32

AUDIO PARAMETERS 35

OTHER PARAMETERS 36

SAVE/REBOOT PARAMETERS 37

Registration Message.............................................................................................................................38

USING AIRLIVE EPHONE-1000 39

To make a phone call .............................................................................................................................39

Review call record ....................................... ........................................................ ...................................39

Speed Dial............................................. ...................................................................................................39

Mute..........................................................................................................................................................40

Hold .................................. .......................................................... ................................................ .............. 40

APPENDIX 41

FREQUENTLY ASKED QUESTIONS 43

- 7 -

Product Specifications

Voice
Call Control Protocol SIP (RFC-3261) or H.323 V4
Voice Compression G.711 A/µ -Law, G.723.1, G.729A/B/AB
Echo Cancellation G.165 16ms
Delay (Point to Point) < 100ms
Average Bandwidth Requirement 10-12k bit/s
Network Protocol RTP/RTCP, UDP/TCP
Support Silence Suppression

VAD, CNGAcoustic Echo CancellationJitter Buffering
DTMF tone detection
E.164 Dial plan
Network Interface
Interface 10 Base-T Ethernet
Connectors Type RJ-45 connector
Configuration Tools

Web BrowserPhone SettingLCD Monitor
IP Address Support PPPoE, DHCP client/Static IP
Firmware Upgrade FTP/HTTP
Other Information

100 – 240VAC, 50 – 60Hz
Power

5VDC, 1A
Power Consumption 3W

Operating Tem perature0 - 40 (32° - 104°F)

Storage T emperature-30 - 65 (-22° - 149°F)

Working Envir onment

Relative Humidity10 – 95% Non-Condensing
Certification CE, FCC

Headset Connection Interf ac eFirmware Upgrade

NAT Pass-through (SIP with STUN)

Other

Speaker phoneHoldMuteRedialSpeed Dial

Received Calls Misse d CallsDialed CallsCall

StatusVo lume Adjustment Voice ResponseWeb

ConfigurationLED indicator, etc..

- 8 -

Package Contents

The AirLive ePhone-1000 Series VoIP phone package contains:

• One AirLive ePhone-1000 VoIP phone

• One power adaptor

• One RJ-45 Ethernet cable

• Quick Installation Guide

• Installation CD

- 9 -

AIRLIVE EPHONE-1000 Functions

Front Panel

- 10 -

Rear and Back Panel

Power Jack 10 Base T Ethernet RJ-45 Jack

Microphone Jack

Earphone Jack

Handset Cord Jack

Wall Mount



Microphone

- 11 -

Function Keys
Keys Function
These keys function with the handset hung
Called

Press the Called key to display the IP address and phone number of the last call

placed.
Ans. Press the Ans. key to display the IP address and phone number of an incoming call.
Miss Press the Miss key to get local IP address of the phone to consult the missed call

number. In addition, dial # to dial this number.
Phone Press the Phone key to get the phone number of the phone. Press again will show

the data in the phone book.
IP With handset hung, press the IP key to get local IP address of the phone.
Mask With handset hung, press the Mask button to get the subnet mask of the AirLive

ePhone-1000.
GATE IP With handset hung, press the GATE IP button to get the gateway IP address in

LAN.
SER .IP With handset hung, press the SER. IP to get the service server IP address.
Hand Free Press this key to turn on the speaker phone.
These keys function at all times
SPD./HOLD Speed Dial; Hold
REDIAL/MUTE Redial; Mute
Vol - Decreases the volume of the handset or speaker; turns the recording back.
Vol + Increases the volume of the handset or speaker; turns the recording back.

- 12 -

Hardware Installation

Plug the power cord into the Power jack of the AirLive ePhone-1000 VoIP

Phone.

Plug the RJ-45 Ethernet cable into the Ethernet jack.

Plug the other end of other cable into the HUB, Router, ADSL Modem, or other

broadband device.

After installing the AirLive ePhone-1000, follow the configuration instructions

in the next chapters.

- 13 -

Configuring the AIRLIVE EPHONE-1000 with the Keypad

AirLive ePhone-1000 can be configured with its keypad or on a web page.

The table below illustrates Configuration Function keys:

Keys Function
SPD./HOLD Change Settings
REDIAL/MUTE Main Menu Options
Vol - Next Page
Vol + Previous Page
Enter Confirm Setting

The Main Menu of the Keypad LCD screen is shown below:

- 14 -

Configuring Network Settings

Network settings allow the AirLive ePhone-1000 to connect to a specific network

environment.

DHCP is the default setting for the AirLive ePhone-1000. This setting enables internet

connections with any DHCP environment.

If either PPPoE or Static IP are used, change the default network setting of AirLive
ePhone-1000 to one of these network environments.

Using the keypad you can select DHCP, Sta tic IP or PPPoE for your network environment

Each of these three options is described below.

Configuring for DHCP

Connect the power adaptor of AirLive ePhone-1000 and connect the PPPoE network

to the RJ-45 port.

Press 1, 2, 3, 4, # (Hold the “#” key)

Enter a [Password]

Press 1, 2, 3, 4 and Enter Æ Network Settings appears.

Press Enter Æ enter the [iptype]

Press SPD/Hold

When the Blinking Cursor appears press 1 and press Enter (1 sets the networking

settings to DHCP).

Configuring for Static IP

Connect the power adaptor to the AirLive ePhone-1000

Connect the PPPoE network to the RJ-45 port.

Press1, 2, 3, 4, # (Hold the “#” key) →enter a [Password]

Press 1, 2, 3, 4 and Enter→ Network Settings appears.

Press Enter→ [iptype] →

Press SPD/Hold→ a Blinking Cursor appears