Outdoor Great Room Sonoma 16 Pergola User Manual
Sonoma 16 Pergola
Manual and Installation Instructions
Please read these instructions before removing parts from crate
Introduction
Thank you for your purchase from The Outdoor GreatRoom Company. This pergola has been engineered and manufactured in
the USA. This user manual will help make the installation and setup of your new pergola fast and easy. Outdoor GreatRoom
company recommends visiting with your local authority for building codes, restrictions, or requirements for this product. Please
read the manual through before starting the project.
This pergola is made of premium grade kiln dried Douglas Fir. Douglas Fir, if maintained properly, will last a very long time,
similar to life of both Cedar and Redwood. All finished pieces have been stained via submersion to ensure even penetration. It is
recommended that the pergola receive a clear, oil-based stain yearly to maintain the color, minimize warping and prevent rotting. Every few years a colored oil based stain should be used to keep the original color.
Important:
• Anchoring Required—Contact your local authority for details
• Read instructions prior to assembly
• Assistance is required and we recommend at least 2 people for installation
• Do not let wood pergolas sit on bare ground. Over time this can cause moisture damage and rotting of wood.
• If you have questions contact the place of purchase
Douglas Fir Lumber may have surface splits. This occurs while the lumber dries and seasons. This characteristic is also known as
“checking” in the lumber industry. These can be upwards of 1/8” running inches to feet in length. These characteristics do not
affect the structural strength and integrity of the product nor does it affect or void the warranty.
Before Beginning, make sure that all components listed on the next page were included with your hardware kit.
Contact your dealer if any parts are missing.
Tools Required
• Corded or Cordless Drill
• Measuring Tape
• Level
• Metric Socket Set
• Rubber Mallet
• Step Ladder
• Hammer Drill*
• Concrete Drill Bit*
• Concrete Anchors*
• Construction grade adhesive (such as PL 400)
*Only Required for anchoring to concrete surfaces.
Disclaimer—The Outdoor GreatRoom Company is not liable for damage caused by weather or misuse
Extreme weather including heat, cold, rain, snow and high humidity affect all wood products. Taking proper care of your pergola is
essential to ensure long-lasting performance and beauty.
NOTE
90222 Sonoma 16 Pergola REV B 4-17-2012
2
Included Parts:
B
B
AAAA
Column
B B
Tall Corbel Post
Tall Corbel Post
Tall Corbel Post Tall Corbel Post
Brace
Brace
BraceBrace
C
C
C C
Short Corbel Post
Short Corbel Post
Short Corbel Post Short Corbel Post
Brace
Brace
BraceBrace
r
e
d
a
e
H
D
D
D
D
4
X
m
a
e
B
r
e
d
a
e
H
E
E
E
E
Arch Mending plate
x10
x10
x10x10
L M
Foot
x4
x4
x4x4
4
X
m
a
e
B
X4
X4
X4 X4
G
G
G G
Canopy Beam, Right L
Canopy Beam, Right L
Canopy Beam, Right LCanopy Beam, Right L
X4
X2
X2
X2 X2
X4
X4 X4
H
H
H H
Canopy Beam, Left L
Canopy Beam, Left L
Canopy Beam, Left LCanopy Beam, Left L
J
J
J J
Arch Beam
Arch Beam
Arch Beam Arch Beam
X4
X4
X4 X4
X2
X2
X2 X2
B
r
e
d
a
e
H
F
F
F
F
I
I
I I
Canopy Beam, T
Canopy Beam, T
Canopy Beam, TCanopy Beam, T
K
m
a
e
2
X
X6
X6
X6 X6
ALL bolts require washers
M10x 55 Hex Bolt (with nut and washers)
x30
x30
x30x30
M10 x160 Hex Bolt
x8
x8
x8x8
N
(with nut and washers)
O
M10 x 90 Hex Bolt (with nut and washer)
x28
x28
x28x28
1.25” Wood screw
3” Wood screw
P
Q
x60
x60
x60x60
R
x120
2” Wood screw
S
x120
x120x120
X10
X10
X10 X10
Rectangular Mending
Plate
X10
X10
X10X10
x8
x8
x8x8
3
Loading...