Outdoor Great Room Patio Pergola User Manual
Patio Pergola
Manual and Installation Instructions
Please read through these instructions before assembly
Introduction
Thank you for your purchase from The Outdoor GreatRoom Company. The purpose of this manual is to make the installation and
assembly simpler. Outdoor GreatRoom company recommends visiting with your local authority for building codes, restrictions, or
requirements for this product. Please read the manual through before starting the project.
This pergola is made of Chinese Cedar. Chinese Cedar, if maintained properly, will last a very long time, similar to life of both
Douglas Fir and Redwood. All finished pieces have stained for beauty and protection. It is recommended that the pergola receive
a clear, oil based stain yearly to maintain the color, minimize warping and prevent rotting. Every few years a colored oil based
stain should be used to keep the original color.
Important:
Anchoring Required—Contact your local authority for details
Read instructions prior to assembly
Assistance is required and we recommend at least 2 people for installation
Do not let wood pergolas touch bare ground. Over time this can cause moisture damage and rotting of wood.
If you have questions contact the place of purchase
Before Beginning, make sure that all components listed on the next page were included with your hardware kit.
Contact your dealer if any parts are missing.
Tools Required
Corded or Cordless Drill
Measuring Tape
Level
Metric Socket Set
Rubber Mallet
Step Ladder
Hammer Drill*
Concrete Drill Bit*
Concrete Anchors*
*Only Required for anchoring to
concrete surfaces.
Disclaimer—The Outdoor GreatRoom Company is not liable for damage caused by weather or misuse
Extreme weather including heat, cold, rain, snow and high humidity affect all wood products. Taking proper care of your pergola is
essential to ensure long-lasting performance and beauty.
NOTE
Assembl y Instructions for 1 0’X1 0’ Patio Pergola: Parts (not e: Extra parts suppl ied for alternat e f ree-st anding inst all ati on)
A
Post
X2
B
Interior Beam
C
Decora-
D
X6
X10 X2
Exterior Beam
F E
G
Corbel
I
“L” Bracket
K
6.25” Post Bolt
X6
X6
X2
H
Foot
J
Mending Plate
L
1” Bolt
X2
X8
X36
Exterior Beam
X2 X2
Interior Beam
N M
3” Corbel Screv
X16
2” Corbel Screv
O
1” Mending Plate Screv
X16
X164
Loading...