Outdoor Great Room Gallery Wall-Mounted Fireplaces User Manual

Tools Required-

 Philips Screwdriver or

power drill with
Philips tip (preferred)

 Leveling device

NOTE: Heater unit may be removed or left attached to the fire box for this installation. Use the provided

diagrams for clearances for each configuration.

 Removing the heater unit (optional)

 Remove 4 screws from underside of heater unit
 Unplug the heater from the fire box by

squeezing the tabs on the white quick
connector plug and pulling downward. Set
heater assembly aside or dispose of
appropriately.

Remove

 Relocate Heat and lighting controls

 Remove the screws holding the access panel on

the underside of the fire box on.

 There is a small quick connect plug inside this

access panel. Plug the control module (included
with this kit) into the quick connect plug and
screw access panel back into place, threading
wire through hole in access panel door.

 Once fireplace is installed into a wall, the

control button module can be mounted to the

wall surface below it using a screw or a
double-sided adhesive strip.

Connect control button module to

fire box

Remove screws

Gallery Wall-Mounted Fireplaces

Installing the fireplace into a wall as a built-in unit

Included in this kit-

 Wall Mounting Brackets (2)
 M5x10 Screws (4)
 Control button relocation module (1)

90238 Rev B 11/8/12

 Prepare Your Wall for Installation

 DO NOT CUT INTO ANY WALL WITHOUT FIRST ENSURING THAT THE AREA IS FREE OF HIDDEN

ELECTRICAL, GAS, OR PLUMBING LINES. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH

 With front glass removed, measure your fireplace. You can then use these measurements to select an

appropriate spot on a wall for inserting your fireplace.

 Use framing clearance diagrams shown on the next page for appropriate cutout sizing.
 IF STUDS ARE NOT PRESENT ON LEFT AND RIGHT SIDES OF CUTOUT, STUDS OR OTHER INTERIOR SUPPORT

SHOULD BE FABRICATED TO SUPPORT THE WEIGHT OF FIREPLACE. SEE DIAGRAM ON NEXT PAGE.

7/8”

13/16”

1/2”

1/2”

1/2”

1/2”

5/8”

5/8”

1 1/8”

1 1/8”

2 1/2”

2 1/2”

5 5/8”

DIMENSIONS SHOWN ARE MINIMUM

CLEARANCES TO FRAMING

FOR FIREPLACES WITH HEATER ATTACHED

DIMENSIONS SHOWN ARE MINIMUM

CLEARANCES TO FRAMING

FOR FIREPLACES WITH HEATER REMOVED

Distance from back of fireplace to a

surface should be 7/8” or greater.

Once installed, the fireplace (including glass front) will protrude
2 5/8” from the wall surface.

90238 Rev B 11/8/12