CONCORDE MKII
UNIVERSAL
USERGUIDE
CONCORDE MKII
UNIVERSAL
USERGUIDE
Thank you for choosing the Or tofon Moving
Magnet cartridge. At Ortofon we constantly look
for new technology to be used in our products,
thus we assure the highest level of performance
and quality. It is our aim to bring you many hours of
new and surprising experience in listening to your
precious collection.
WARNING
This phono cartridge is only for mounting on tonearms
and must not be used for other purposes.
PLEASE NOTE
To avoid damages on the stylus please keep the st ylus
guard on the cartridge any time when mounting or
dismounting the unit.
MOUNTING THE CONCORDE
CARTR IDGE
Ortofon Concorde cartridge is for direct and easy
mounting on the tonearm, no alignment is required.
THE OPTIMUM TRACKING
WEIGHT SETTING :
Tracking Force Recommended refers to the optimal
weight which will result in the best combination of
groove holding and sound. Take care not to deviate
outside of the Tracking Force Range, as it may result in
skipping, poor sound quality, or unnecessary wear on
your vinyl.
STY LUS CARE
• Remove dust carefully from record sur faces by using a
fi ne antistatic brush before every use.
• We do not recommend the use of solvents of any kind
for cleaning of either record surface or stylus, as they
can weaken the stylus or cause damage to the internal
components of the cartridge.
• For cleaning the stylus, use stylus brush a few times
along the cantilever in the direction of the stylus tip,
whenever you play a new record or change sides. Use
the brush in the forward direction from the rear of the
cartridge towards the stylus tip and never from st ylus
tip to the rear of the cartridge and never from side to
side.
• Remove dust from the diamond tip before and after
playback of each record.
• Make sure to follow setup guidelines as suggested by
the specifi cations found in the manual (or found on our
website).
CONCORDE MIX DJ CLU B SCRATCH DIGITAL
Output vo ltage at 1,000 Hz, 5 cm/se c. 6 mV 6 mV 8 mV 10 mV 10 mV
Channe l balance at 1 kHz 1.5 d B 1 dB 1 dB 1 dB 1 dB
Channel separation 1 kHz 20 dB 22 dB 25 d B 22 dB 22 dB
Channel separation 15 kHz 15 dB 15 dB 15 dB 15 dB 15 dB
Frequen cy range at - 3 dB 20 – 20,000 Hz 20 – 20,000 Hz 20 – 20,000 Hz 20 – 18,000 Hz 20 – 18,000 Hz
Tracking ab ility at 315 Hz
at recommended tracking force
Compliance, dynamic lateral 14 µm /mN 14 µm /mN 14 µm /mN 14 µm /mN 14 µm /mN
Stylus type
Tracking force range 2 – 4 g 3 – 5 g 2 – 4 g 3 – 5 g 3 – 5 g
Tracking force recommended 3 g 4 g 3 g 4 g 4 g
Interna l impeda nce, DC resi stance 700 Oh m 700 Oh m 1000 Ohm 120 0 Oh m 120 0 Oh m
Internal inductance 450 mH 450 mH 650 mH 850 mH 850 mH
Recommended load resistance 47 kO hm 47 kO hm 47 kO hm 47 kO hm 47 kO hm
Recommended load capacitance 200 – 600 pF 200 – 600 pF 200 – 600 pF 200 – 400p F 200 – 400 pF
Cartridge weight 18.5 g 18.5 g 18 .5 g 18.5 g 18 .5 g
Replacement stylus unit Mix DJ Club Scratch Digital
100 µ m 100 µ m 100 µ m 120 µ m 10 0 µm
Spherical
R 18 µm
Spherical
R 18 µm
Special Elliptical
r/R 13/25 µm
Spherical
R 18 µm
Spherical
R 18 µm
Get more information about
Ortofon DJ cartridges
For more information please refer to Ortofon DJ FAQ:
www.ortofon.com/support/support-dj/faq-setup
Ortofon A /S
Stavangervej 9
DK-4900 Nakskov
Denmark
support@ortofon.dk
www.ortofon.com
03-21/5-800150-12
Loading...