3. Hang Display onto the Wall Plate
wall
Tighten bottom bolts to secur e display brackets to the wall plat e.
wall
4. Adjustment
Tilt adj us ting knob
Bolt
730 0 Bolsa Av e. , Wes tm ins ter, CA 926 83 -
Pre mium Mo unt Inc
Pho ne: 714 -766- 6303
Tilting Wall Mount
INSTALLATION INSTRUCTIONS
0°
-1 0°
Loo se the adju st ing knobs t o tilt de si red angle t hen tight en them.
Maintenance
• Check that the bra cket is secure and safe to use at regul ar intervals(at least eve ry thr ee months).
• Please contact y our dealer if you have any ques tion s.
7
WB-4663
400x20 0/ 40 0x 40 0
600x40 0/ 80 0x 40 0
CA UT IO N : DO N OT EX CE ED M AX IMU M
LIS TE D WE IG HT CAPAC IT Y. SERIOU S
INJURY OR PR OP ERTY DA MA GE MAY
OCCUR !
63"
MAX
75kg
(165lbs)
MAX
ISSUED: OCT.2012
NOTE : Rea d the ent ire i nstru cti on manu al be fore yo u sta rt inst all ation a nd as sembl y.
WARNING
• Do not begin the installation until you have read and understood the instructions
and warnings contained in this installation sheet. If you have any question
regarding any of the instruction or warning, please contact your local distributor.
• This mounting bracket was designed to be installed and utilized ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• This product should only be installed by someone of good mechanical ability,
with basic building experience and fully understanding of this manual.
• Make sure that the supporting surface will safely support the combined load of
the equipment and all attached hardware and components.
• If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. The use of a stud finder is highly recommended.
• Always use assistant or mechanical lifting equipment to safely lift and position
equipment.
Component Checklist
IMPO RTANT: Ensure t ha t yo u ha ve r ec eived a ll p ar ts a cc or ding to the c om po ne nt c hecklis t pr io r to i ns talling . If
any p ar ts a re m is si ng or fau lt y, te le phone y ou r lo ca l di st ribut or f or a r ep la ce ment.
right (x1)adapt er b ra ck et
C
M6x30 (x 4)
M-D
Pack age M
M5x14 (x 4)
wall pla te
A
M-A
(x1)
M6x14 (x 4)
M-B
left (x1)adapte r br ac ke t
B
M8x20 (x 4)
M-C
• Tighten screws firmly, but do not over tighten. Over tightening can damage the
items, greatly reducing their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
1
M8x30 (x 4)
Pack age W
M-E
ST6.3x 55 ( x6 )
W-A
washer
(x4)
M-F
concre te a nc ho r (x 6)
small sp ac er ( x8 )
M-G
W-B
big spac er ( x4 )
M-H
D6 washe r (x 6)
W-C
2