730 0 Bolsa Av e., We stm inst er, CA 92 683 -
Pre mium Mo unt Inc
Pho ne: 714 -766- 6303
INSTALLATION MANUAL
Full Motion LED, LCD TV Wall Mount
WB- 3 0
75x75 /10 0x1 00
CA UTI ON : DO NOT EXCE ED RATED
LIS TED W EIG HT CAPA CIT Y. SE RIOU S
INJ URY OR P ROP ERTY DAMA GE MAY
OCC UR!
"
23
MAX
15kg
15kg
(33lbs)
(33lbs)
RATE D
RATE D
ISSUED: JAN. 2013
NOTE: Rea d the entire instr uction manual be fore you st art ins tallati on and as sembly.
WARNING
• Do not begin the installation until you have read and understood the instructions
and warnings contained in this installation sheet. If you have any question
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
Component Checklist
IMPORTANT: En sure that y ou ha ve re cei ved all par ts ac cor din g to the comp one nt ch eck list prio r to in sta lla tion.
If an y par ts ar e mis sing or fau lty, t ele phone you r loc al di str ibutor fo r a rep lac eme nt.
• This product should only be installed by someone with good mechanical ability
who has basic building experience and fully understands this manual.
• Make sure that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
• If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. The use of a stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
Package M
M4x14 ( x4)
Package W
wall mount (x1)
A
M-A
ST5.5 x50 ( x2)
W-A
M5x14 ( x4)
M-B
D5 wash er (x 4)
concr ete a nch or (x 2)
W-B
Allen key (x1)
B
M-C
21
1a. Wood Stud Wall Mounting
50mm
50mm
50mm
(2")
2"( )
(2")
ø 4mm
(ø 5/32”)
1b. Solid Brick and Concrete Mounting
55mm
55mm
2.2"( )
(2.2")
ø 8mm
(ø 5/16")
W-A
1
2
Find an d mar k the
exact l oca tio n of
mount ing h ole s
3
Drill pilot holes
√
X X
Screw the wall
mount onto the
wall
W-B
W-A
1
Mark th e
exact l oca tio n of
mount ing h ole s
2
Drill pilot holes
√
X X
Screw the wall
mount onto the
wall
WARNING
• Make sure that mounting screws are anchored into the center of the studs. The use of a stud
finder is highly recommended.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
3
WARNING
Install ers must verify that the supporting surface will safely supp ort the combined weight of the
equipment and all attached hardware and components.
4
2. Attach the Display to the VESA Plate
M-A/M -B
Lift th e dis pla y and m atch the holes on y our d isp lay w ith the holes on th e mou nt. S ecu re your display t o
the mou nt by t igh ten ing screws.
Tig hten all screws b ut do n ot ov er ti ghten.
M-C
3. Adjustment
18 0° 18 0° 18 0°
Adjust to the desired locati on or tilt.
B
Tension is pre-set at the factory. If too tight or too
loose, you may adjust the tensi on by loosen ing or
tightening the head and arm adj ustment bolts.
+70°
-70°
B
Tighten the adjustment screw by using an Allen Key provided to fix the tilting angle.
Maint ena nce
• Check t hat t he br ack et is s ecure and sa fe to u se at r egu lar intervals (at l eas t eve ry three months ).
• Pleas e con tac t you r dealer if you hav e any q ues tio ns.
65
Loading...