Orion WB-2642 User Manual

3. Hang Display onto the Wall Plate

wall

Tighten bottom bolts to secure display brackets to the wal l plate.

wall

4. Adjustment

Tilt adju sting kno b

Bolt

730 0 Bolsa Av e., We stm inst er, CA 92 683 -

Pre mium Mo unt Inc

Pho ne: 714 -766- 6303

Tilting Wall Mount

INSTALLATION INSTRUCTIONS

0°

-1 0°

Loo se the adju sti ng knobs to tilt de sir ed angle th en tighte n them.

Maintenance

• Check that the b racket is secure and safe to use at reg ular intervals(at lea st every three months).

• Please conta ct your dealer if you have any questions.

7

WB- 264 2

200x2 00/ 300 x30 0
400x2 00/ 400 x40 0

CA UTI ON : DO NOT EXCE ED MA XIMUM

LIS TED W EIG HT CAPA CIT Y. SE RIOU S
INJURY OR P ROP ERTY DAMA GE MAY
OCCUR!

47"

MAX

75kg

(165lbs)

MAX

ISSUED: OCT.2012

NOTE: Rea d the entire instr uction manual be fore you st art ins tallati on and as sembly.

WARNING

• Do not begin the installation until you have read and understood the instructions
and warnings contained in this installation sheet. If you have any question
regarding any of the instruction or warning, please contact your local distributor.

• This mounting bracket was designed to be installed and utilized ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.

• This product should only be installed by someone of good mechanical ability,
with basic building experience and fully understanding of this manual.

• Make sure that the supporting surface will safely support the combined load of
the equipment and all attached hardware and components.

• If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. The use of a stud finder is highly recommended.

• Always use assistant or mechanical lifting equipment to safely lift and position
equipment.

Component Checklist

IMPORTANT: En sure that y ou ha ve re cei ved all par ts ac cor din g to the comp one nt ch eck list prio r to in sta lli ng. I f

any p art s are m iss ing or faulty, te lep hone your l oca l dis tri butor for a r epl ace men t.

right (x1)adap ter b rac ket

C

M6x30 ( x4)

M-D

Package M

M5x14 ( x4)

wall pl ate

A

M-A

(x1)

M6x14 ( x4)

M-B

left (x1)adapt er br ack et

B

M8x20 ( x4)

M-C

• Tighten screws firmly, but do not over tighten. Over tightening can damage the
items, greatly reducing their holding power.

• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.

1

M8x30 ( x4)

Package W

M-E

ST6.3 x55 ( x4)

W-A

washe r

(x4)

M-F

concr ete a nch or (x 4)

small s pac er (x 8)

M-G

W-B

big spa cer ( x4)

M-H

D6 wash er (x 4)

W-C

2