Orion Onyx Getting Started

GETTING
STARTED

For more info, user guides, and ways
to wear, visit exploreonyx.com.

This device complies with part 15 of the FFC Rules. Operation is subject to
the following to conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

This device complies with industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes: 1) l’appareil ne doit pas produire de brouillage; 2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.

IMPORTANT! Changes or modifications not expressly approved by Orion
Labs could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

CAN ICES-‐3 (B)/NMB-‐3(B)

“Made for iPod,” and “Made for iPhone,” mean that an electronic accessory
has been designed to connect specifically to iPod, or iPhone, respectively,
and has been certified by the developer to meet Apple performance
standards. Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards. Please note that the use
of this accessory with iPod, or iPhone may affect wireless performance.

Active

Twist the face to
the far left (lights
aligned with clip) to
be able to send and
receive audio.

Silent

Twist the face to
the right (lights
centered between
clip) for silent mode.

Power On/Off

Twist the face to the
far right and hold until
you feel the vibration,
then release.

MEET ONYX

Charge Onyx by connecting to a power

source with the included charging cable.

Download the Orion app to get started.

Twist Face

VolumeTalk

(Press
& Hold)

Headphone Port

Charge Port