Setting Barometric Pressure
WMR928N/NX & WMR112
Step 1 Get your current barometric pressure reading.
Go to http://www.bom.gov.au/
barometric pressure. You may already know this from your local airport,
newspaper, radio TV or coastguard etc.
Eg 1020 hPa
Step 2 Calibrate your main unit.
• Go to your main unit and press the touch the “BARO” section (the left
section of the main unit) until you see the words “SEA LEVEL”
• Go the bottom section of the screen on you main unit and touch and
hold “SET” until you see the digits flash.
• Then use “Up” or “Down” arrow keys to enter the current local pressure
reading
• Touch the set button once and your “SEA LEVEL” reading will appear.
Notes
• If you want to have a look at your location barometric pressure press
the “BARO” section once to view this reading
• To get back to “sea level” reading press this section once again to
switch between.
Your unit is now calibrated to your
and get your current local reading for