RADIO-CONTROLLED
PROJECTION CLOCK
MODEL NO.: RM868PA
USER’S MANUAL
SECTION 1 INTRODUCTION
Congratulations on your purchasing the RM868PA Radiocontrolled Projection Clock.
The Projection Clock is a compact, easy-to-handle device. It is
designed to automatically synchronize its current time and date
when brought within range of the U.S. Atomic Clock.
The Projection Clock also comes with features such as clock
projection, multilingual day-of-the-week display, back-light, dual
analog and digital displays of time and daily alarm with 8-minute
snooze function.
GB
1
GB
DISPLAY BUTTONS
A DIGITAL CLOCK DISPLAY
B ANALOG CLOCK DISPLAY
CONTROL BUTTONS
C [MODE/SET] BUTTON
Changes the display mode or holds to enter the setting routine
D [ALARM] BUTTON
Sets the daily alarm function
E[
F[ ] BUTTONS
G[
H [RESET] BUTTON
I [PROJECTION ON] BUTTON
J[ ] [IMAGE ROTATION] KNOB
] BUTTON
ZONE
Selects among the 4 U.S. time-zones: Pacific, Mountains, Central
or Eastern
Change the value of a setting
] BUTTON
SNOOZE
Activates the snooze function or turns on the back-light and
clock projection
Returns all settings to default values
Used with power adapter to enable continuous projection
90º (left or right) image rotation
K [180º ROTATION] BUTTON
Flips the projected image horizontally
L [FOCUS] KNOB
Adjusts the focus of clock projection
M 3 V DC JACK
For AC power adapter installation
N WALL - MOUNT HOLE
O PROJECTOR
POWER
This unit can be operated by batteries or AC power alone as well as
both together.
Battery Installation:
The unit uses two AA-sized (UM-3) 1.5V batteries which is installed
in the factory for you. Please remove the plastic cover before usage.
Should you need to change the battery,
2
1. Remove the battery compartment door.
2. Insert two AA-sized (UM-3) 1.5V batteries as shown.
3. Press [RESET] .
4. Replace the battery compartment door.
To install the adapter:
1. Insert adapter into jack at the bottom of the unit.
2. Plug the adapter into an electrical wall outlet.
When the power level of the installed batteries is low or when only
AC adapter is connected, the low battery indicator [ ] will light
up. In this case, replace or install with new batteries .
HOW TO ACTIVATE THE BACK-LIGHT
Press [
] to turn on the back-light for 5 seconds.
SNOOZE
HOW TO USE THE CLOCK PROJECTION
The clock projection makes it easier for you to read the Current time
or Alarm time with alarm-on/off status at night. To use the feature,
1. Press [
current time with alarm-on/off status ( [ ] on or off) will be
projected onto the surface the lens is facing.
2. To change to view the preset alarm time with its on/off status,
press [
] to turn on the projection for 5 seconds. The
SNOOZE
] when projection is already on.
SNOOZE
GB
Note: Make sure the voltage is correct.
Current Time &
Alarm-on/off Status
3. Adjust the projected image as below.
3
Alarm Time &
Alarm-on/off Status
Loading...