ORBIT FR FR8305 User Manual

Gating Hardware
Gating Hardware
Gating HardwareGating Hardware
Pulse Modulator / Downconverter
ORBIT/FR offers a complete line of pulse modulators covering the frequency range from
0.1 to 110 GHz. The FR8305 Series covers 18 to 110 GHz. Each product is designed to use your existing receiver and sources. The FR8305 Series provides the excellent sensitivity that is critical for minimizing the required amounts of averaging and reducing test times.
For Frequencies from 18 to 40 GHz
To cover the 18 to 26.5 and 26.5 to 40 GHz bands, ORBIT/FR offers the FR8305A/K and FR8305B/Ka, respectively. Each of these units are self-contained, fully integrated down­converters, up-converters, and pulse modulators. No external frequency converter is required with either of these two units. You can even use your existing RF synthesizer, even if it only operates to 20 GHz. These units require a second synthesizer to serve as the LO source. The low cost Agilent 83621A functions well as the LO source. The output of these pulse modulators is the 20 MHz IF required by the Agilent 8510BC Network Analyzer or Agilent 8530A Microwave Receiver.These units are efficiently packaged in a single 5.25" high standard EIA chassis capable of shelf-top or rack mount installations. A waveguide interface to a quasi-monostatic radar antenna configuration is provided at the rear
panel in the standard configuration. An optional monostatic waveguide configuration or optional
2.9 mm coaxial antenna interface is also available. Type 'N' IF jacks are also provided on the rear panel for both the Transmit Reference and Receive Test IF channels. These channels are connected directly to the Agilent 8510C/8530A
For Frequencies from 40 to 110 GHz
ORBIT/FR also offers a line of Pulse Modulators for operation at the higher millimeter-wave frequencies. Bandwidths as wide as 10 percent are supported with output power levels designed to requirements. As with the FR8305A/K and FR8305B/Ka modulators, each of the high band units are self-contained, fully integrated down­converters, up-converters, and pulse modulators. No external frequency converter is required. These units are compactly packaged in two single 5.25" high standard EIA chassis (RFU & PSU) capable of shelf-top or rack mount installations. A waveguide interface to a quasi­monostatic radar antenna configuration is provided at the rear panel in the standard configuration. · Higher power levels are optionally available with decreased bandwidth.· Broader bandwidths are optionally available.
FR8305 Series
RCS PRODUCTS
26
26
2626
Gating Hardware
Gating Hardware
Gating HardwareGating Hardware
RF Characteristics
Operating Frequency GHz 26.5 to 40 18.0 to 26.5 92.5 – 95.5
Peak Output Power dBm +13 Typ. +13 Typ. +13 Typ.
System CW Noise Floor at 8510C (no aver­aging)
0.1 dB Compression Power dBm -45 Typ. -120 Typ. -45 Typ.
Dynamic Range (no averaging) dB 75 dB Typ. 75 dB Typ. 75 dB Typ.
RF Input Requirements dBm 8.67 to 13.33 GHz at
LO Input Requirements: dBm 6.625 to 10.05 GHz
Output Connector: WR-28 WR-42 WR-10
Transmit Pulse Characteristics: Pulse Width: Pulse Width Resolution: Rise/Fall Time: On/Off Ratio:
Receive Gate Characteristics: Pulse Width: Pulse Width Resolution: Rise/Fall Time: On/Off Ratio:
Electrical 115/230 VAC+/- 10%
dBm -118 Typ. -120 Typ. -113 Typ.
FR8305A/K FR8305B/Ka FR8305B/W
-2 dBm Typ.
at 0 dBm Typ.
10 nS to 500 nS 1 nS 2 nS Typ. 100 dB Typ.
10 nS to 500 nS 1 nS 2 nS Typ. 100 dB Typ.
47 to 63 Hz Single Phase
9.0 to 13.25 GHz at ­2 dBm Typ.
9.0 to 13.25 GHz at 0 dBm Typ.
10 nS to 500 nS 1 nS 2 nS Typ. 100 dB, Typ.
10 nS tp 500 nS 1 nS 2 nS Typ. 100 dB, Typ.
115/230 VAC+/- 10 47 to 63 Hz Single Phase
15.4 to 16 GHz at 0 dBm Typ.
11.5 to 12.0 GHz at +6 dBm Typ.
10 nS tp 500 nS 1 nS 6 nS Typ. 100 dB Typ.
10 nS tp 500 nS 1 nS 6 nS Typ. 100 dB Typ.
115/230 VAC+/- 10 47 to 63 Hz Single Phase
RCS PRODUCTS
Dimensions: 17" (43.2 cm) wide
5.25" (13.3 cm) high 17" (43.2 cm) deep
Options
Opt. 001 - Add Timing Unit X X X
Opt. 002 - 2.9mm Coaxial Antenna Interface X X
Opt. 003 - Monostatic Antenna Interface X X X
Opt. 101 - Additional Manual X X X
X X X Opt. 102 - International Localization
17" (43.2 cm) wide
5.25" (13.3 cm) high 17" (43.2 cm) deep
Supplied Accessories
Operating and Maintenance Manual
Rack Mount Kit
Interconnect Cables
PRF Calculator Shareware
North American Power Cord
27
27
2727
Loading...