Orbit T944 Owner's Manual
Content
Manual and Reference -----------------------------------------------------------------------2
Assembly Instructions-----------------------------------------------------------------------3-5
Folding Instructions ----------------------------------------------------------------------------6
Technical Parameter --- ----------------------------------------------------------------------7
Grounding methods ---------------------------------------------------------------------------7
Operation Instructions---------------------------------------------------------------------8-12
Exercise Instruction --------------------------------------------------------------------------13
Maintenance Instruction---------------------------------------------------------------------14
Running belts centering ---------------------------------------------------------------------15
Exploded Drawing ----------------------------------------------------------------------------16
Parts list ------------------------------------------------------------------------------------17-18
1
2
MANUAL AND REFERENCE
WARNING
Read all instructions carefully before using this product. Retain this owner’s manual for future reference:
----When using this treadmill, keep the safety pull pin rope attached to your clothes.
----When you are running, keep your hands swinging natural, look forward,
Never look down at your feet.
----Increase the speed step by step when running.
----When emergency happens, stop the treadmill by pulling the safety stop switch cord that should be
attached to your clothing immediately.
----Leave the treadmill only after the running belt has stopped completely.
Caution: Read the assembly instruction carefully, follow the instructions when
assembling.
ATTENTION
1、 Before starting any exercise program, consult with your physician or health professional.
2、 Check all the bolts are tight.
3、 Never put the treadmill in wet areas, or it will cause problems and void warranty.
4、 We take no responsibility for any problems or injuries due to above reasons.
5、 Dress in sport clothes and shoes before running.
6、 Do not do exercise at least 40 minutes after eating a meal.
7、 To prevent injuries, please warm up before exercise.
8、 Consult with doctor before exercise if you have high blood pressure or any health issues.
9、 The treadmill is only used for adults。
10. Provide the elderly, children and handicapped with good adult supervision.
11、Do not plug anything into any parts of this equipment, or it may cause damage.
Do not lengthen the power cable or change the power cable plug; do not put any thing heavy on the
power cable or put the power cable near heat source;
12、Cut off the power when the equipment is not in use. Unplug power cord from wall socket , do not
pull the power
cord when removing the plug from the wall socket.
ASSEMBLY INSTRUCTIONS
When you open the carton, you will find the below spare parts:
Spare parts list：
No.
Description Specification Qty
No.
Description Specification Qty
1 Main Frame 1 83
Sheet metal screw
M6*16
6
3 Left upright tube 1 88
Lock washer
10 12
4 Right upright tube 1
20
5#
Allen Wrench
5 mm 1
10 Handle bar tube 1
21
6#
Allen Wrench
6 mm 1
113
Console frame 1
22
Philip Screw driver
S=13、14、15
1
67
Socket flat head bolt
M10*20 12
FIXING TOOLS:
5#ALLEN WRENCH 5mm 1pcs、6# ALLEN WRENCH 5mm 1pcs
WRENCH W/SCREW DRIVER S=13、14、15 1pcs
3
Notice: Do not turn on before assembly is done.
ASSEMBLY STEP 1：
4
Open the carton，get out the above spare
parts ， put the MAIN FRAME on the
ground.
ASSEMBLY STEP 2:
Use the 6# allen wrench, drill through the
bolt (67) to Lock washer(88), then lock
the Left upright (3) onto MAIN FRAME (1)
ASSEMBLY STEP 3:
1、 Connect the computer middle
wire(117) under the right
upright tube with computer
lower wire(118) on the main
frame. Then insert the right
upright (4) into main frame(1)
Warning: Please note not to
damage the wires.The connect
method is shown on lable(126)
2 、 Use 6# wrench, M10*20
screw(67) and flat head bolt to fix the
Right upright to Main Frame(1)
ASSEMBLY STEP 4:
5
Pull through the computer middle
wire of Handle bar tube(10) from
the left and right Upright(3,4).
Then insert the handle bar tube
into left and right upright;
2、Fix the handle bar tube(10) and
left/right upright with screw driver
and M6*16 sheet metal screw(83)
1.Connect the computer upper
wire(116,127,134,135) with
computer middle wire(117a) out of
the Left/Right Upright(3,4).
ASSEMBLY STEP 5:
Warning: Please make sure note
not to damage the wires. The
connect method is shown on
lable(126)
2.Use wrench, M10*20 screw(67)
and washer(88) to fix the
computer (113) to the left/Right
Upright（3,4）
ATTENTION：Please complete all assembly instruction before tightening
and checking all bolts. Do the following operation after checking
everything is OK. Before you use the treadmill, pls read the instruction
carefully.
Loading...