
READ AND SAVE THESE INSTRUCTIONS
Orbit Industries, Inc.
Economy Plus
“OEP” Series
OEP80
OEP90
WARNING:
OEP110
“WARNING - To Reduce The Risk Of Electric Shock,
Do Not Use This Fan With Any Solid-State Speed Control Device.”
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSON, OBSERVE THE FOLLOWING:
a) Use this u nit only in the manner inte nded by the manufa cturer. If you have questi ons, contact the m anufacturer.
b) Before s ervicing or cleaning unit, switch power o ff at service pa nel and lock the service disconnecting me ans
to preven t power from being switch ed on accidental ly. When the serv ice disconnecting mea ns cannot be
locked, s ecurely fasten a promin ent warning devi ce, such as a tag, to the servi ce panel.
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSON, OBSERVE THE FOLLOWING:
a) Instal lation work and electri cal wiring must be d one by qualified p erson(s) in accordanc e with all applica ble
codes and s tandards, including f ire-rated cons truction.
b) When cut ting or drilling into wal l or ceiling, do not d amage electrical wiring and other hidde n utilities.
c) Ducted f ans must always be vented t o the outdoors.
d) If this un it is to be installed over a tu b or shower, it must be m arked as appropriate fo r the applicatio n and be
connect ed to a GFCI (Ground Fault Ci rcuit Interrup ter) - protected branch c ircuit.
a) "Do not install fan above or inside a 45-degree angle projected outwards
from the cooking equipment element closest to the fan. See instruction
sheet for clarification;" or
b) "Not for use in cooking area - see installation instructions;"
" Do Not Mount In A Ceiling Thermally Insulated To A Value Greater Than R40"
"CAUTION - For General Ventilating Use Only. Do Not Use To Exhaust Hazardous Or
Explosive Materials And Vapors."
WARRANTY OWNER: Orbit Industries, Inc., warrants to the original consumer purchaser that it’s products will be free from
defects in materials or workmanship for a period of one year from the date of original consumer purchase.
THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
During this one year period, Orbit, will at its option, repair or replace , without charge, any products or part which is found to be
defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR
TUBES, FILTERS, DUCT, ROOF CAPS, and OTHER ACCESSORIES FOR DUCTING.
This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to
misuse, negligence, accident, improper maintenance of repair (other than by Orbit), faulty installation or installation contrary to
recommended installation instructions. The duration of any implied warranty is limited to the one year period as specified for the
express warranty. Orbit OBLIGATION TO REPAIR OR REPLACE, AT Orbit OPTION, LIABLE FOR INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR
PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusive may not apply to you. This warranty gives you specific legal rights, and you may have other rights, which
vary from state to state. This warranty supercedes all prior warranties.
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify Orbit at the address stated below, (b) give the
model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting
warranty service, you must present evidence of the original purchase date.
Orbit Industries, Inc. 2100 S. Figueroa St. Los Angeles, CA 90007 Tel: (213) 745-8884 Fax: (213) 745-2015 1-800-90-ORBIT

Sliding
Economy Plus
“OEP” Series
OEP80, OEP90, OEP110
4” termination (duct)
Rough Opening:
L 10 3/4” x W 10 3/4”
Housing Dimension:
L 10 5/8” x 10 5/8” x H 7 5/8”