Optimus AMX-10, 40-1403 User Manual

40-140 3.fm Page 1 Wednesday, August 11, 199 9 7:47 AM
Cat. No. 40-1403
OWNER’S MANUAL
Please read before using this equipment.
AMX–10
Stereo Amplified Speakers
40-140 3.fm Page 2 Wednesday, August 11, 199 9 7:47 AM
INTRODUCTION
The speakers also transform your por­table CD player or personal cassette player into a complete music system. The speakers are com pat ible with any audio source that has a
1
/8-inch stereo
headphone or line out jack. Your speakers’ features include:
1
3
/2-Inch Full-Range Speakers
give you excellent, wide-range sound.
Bass Boost and Treble Co ntrols
— let you adjust the speakers’ low and high frequency response to enhance the sound.
POWER SOURCES
You can power your speakers from in­ternal batteries, standard AC power, or vehicle battery power.
Using Batteries
You can power the speakers from eight C batteries (four in each speak­er). For the best performance, we rec­ommend alkaline batteries, such as RadioShack Cat. No. 23-651.
1. Press the tab on each speaker’s battery compartment cover, then lift off the cover.
2. Put four batteries into each speaker’s compartment, as indi­cated by the polarity symbols (+ and –) marked inside the compart­ment.
Caution:
of the required size and type.
3. Replace the cover.
Use only fresh batteries
© 1996 Tandy Corporation.
Optimus is a registered trademark used by Tandy Corporation.
RadioShack is a trademark used by Tandy Cor poration.
All Rights Reserv ed .
2
40-140 3.fm Page 3 Wednesday, August 11, 199 9 7:47 AM
Notes:
• If you will not be using t he spea k­ers for a week or more, or if you will be using only AC or vehicle battery power, remove the batter­ies from each speaker.
• If the speakers’ sound weakens or distorts, or the power indicator dims during use, replace all the batteries in both speakers.
Caution: Always dispose of old bat­teries promptly and properly.
Using AC Power
You can power your speakers from a standard AC outlet using a 12-volt AC adapter (not supplied), such as Ra­dioShack Cat. No. 273-1653.
Cautions:
• The recommended adapter sup­plies 12 volts DC power and deliv­ers at least 600 milliamps. Its center tip can be set to positive, and its plug properly fits the right speaker’s adapter that does no t meet these specifications could damage the speaker or the adapter.
DC 12V
jack. Using an
Follow these steps to use AC power.
1. Make sure
OFF
to
POWER OFF/ON
.
is set
2. Plug the 5.5 mm outer diameter/
2.1 inner diameter barrel plug into the AC adapter cord, matching TIP to positive (+).
3. Plug the adapter ’s barrel plug into the
DC 12V
jack on the rear of the
right (R) speaker.
4. Plug the adapter into a standard AC outlet.
Note: Connecting a n AC adapter au­tomatically disconnects internal batter­ies.
• Always plug the AC adapter into the speaker before you plug i t into the AC outlet. Always un plug the AC adapter from the AC outlet before you unplug it from the speaker.
3
Loading...
+ 5 hidden pages