Oppo BDP-103EU, BDP-103, BDP-103AU Installation Instructions And Specifications

Installation Instructions

Oppo BDP-103 / BDP-103EU / BDP-103AU

regionfree modification

Figure 1

Disconnect the mains cable, and remove the top plate of the player.
Note the yellow marked point where the cable must be inserted. Only one cable needs to
be inserted.

Attach the board to the side panel of the chassis. The board has double-adhesive tape for
this.

Figure 2

Now the kit is ready for operation. This is how to use the kit:
By default, your bluray player is region free for DVD. To set the bluray region to A, B or C,
please do the following:

1. Power on the player without any disc inserted. The screen will after a

while show “No Disc”.

2. About 4 seconds after the “No Disc” or “HOME MENU” displayed, press DIMMER,
DIMMER, DIMMER, MUTE and then the region code. 1 for A, 2 for B, and 3 for C.

3. Power off your player. When started up again, the regioncode has changed.

The region code selection must be done within 20 seconds.
Your players firmware must be the BDP103-38-1211 release, or newer.

To select a specific DVD region, press DIMMER , DIMMER , DIMMER , PURE AUDIO, x
Where x is the DVD region 0 to 6. Default is 0 (all regions / regionfree)