Onkyo TXSR-803, TXRS-703 Service Manual

CONFIDENTIAL

TXS-R703/TXS-R803

Technical Tip

18 Park Way, Upper Saddle River, NJ 07458

Date: May 24, 2006

_____________________________________________________________
Model: DTR-4.6/5.6/6.6/7.6

Subject: Remote and Wired remote does not respond well to input commands

Symptom: When using remote or an external IR controller connected to the rear panel IR input

the set may not respond properly to IR commands.

Solution:

Install the IR Shield PC Board as described. Cover the IR Remote Sensor.

______________________________________________________________________________________

This document and the information it contains is intended for the exclusive use of Authorized ONKYO Service Centers and their
employees. This document may contain information that is privileged, confidential and exempt from disclosure under applicable law
and terms of the ONKYO Service Agreement. Any dissemination, distribution or copying of this document and the information it
contains is strictly prohibited.

1.) Solder the Terminal Connector to the PC board.

2.) Attach the PCB you assembled to the set using a self tapping screw.

CONFIDENTIALITY NOTICE:

Parts:

Ref# Description Part Number

NA Solder Terminal 25060312
NA PC Board NCETC-8663 25138663
NA Self Tapping Screw 831430088

______________________________________________________________________________________

CONFIDENTIALITY NOTICE:

This document and the information it contains is intended for the exclusive use of Authorized ONKYO Service Centers and their
employees. This document may contain information that is privileged, confidential and exempt from disclosure under applicable law
and terms of the ONKYO Service Agreement. Any dissemination, distribution or copying of this document and the information it
contains is strictly prohibited.