Onkyo SKW 30 Service Manual

SKW-30-BUL-1

11/22/01

SKW-30

Symptom:

Solution:

detached from the main PCB solder terminal. The voltage through R16 may not arrive at its intended
target should this happen causing unit not to operate. Make a jumper wire from one end of R16 as
seen to the block solder terminal VCC point.

Warning:

source and discharge power supply capacitors very slowly. Do not introduce instant discharge of the
power supply filter capacitors, as it would harm the power block.

No power at all

In some instances the power supply block VCC input solder point may be cracked or

When performing this procedure one must make sure unit is not plugged to the any power

Solder at point A VCC input
may crack or come loose. Add
wire as indicated to stabilize
trace from Power block VCC
leading up to R16 solder end
as seen.