BT datas
Chipset :QCC3034
BT version:V5.0
Adjust Form:GFSK
Offer voltage:3.0-4.2V
Support BT agreement: A2DP,AVRCP,HFP,HSP
Working current ≤20mA
Standby current ≤2mA
Charging current :100mA
Wireless transmit distance:10 meter
Out power:MAX 6dBm
RF: -80dBm<0.1%BER
SE-C7BTSE User manual
Frequency range :2.4GHz-2.480GHz
Signal to Noise Ratio:≥75dB
distortion factor: ≤0.1%
Temperature: 0ºC to +45ºC
1.Indicator
2 Volume+ / next chart
3． Volume- /previous chart
4． ON/OFF /play/pause
5． Usb 5 V Output
Feature:
Enjoy music through Bluetooth
Phone call with BT function
Remote control music
High sensitivity,omnibearing microphone design
Apply for devices:with all BT mobile phone,iphone,Laptop Etc.
Pairing:red&blue light blinking
Pairing successful:blue light slow blink
Charging: red light on,full charge blue light on
一. BT earphone pairing
1.press and hold （ ）3s open Pioneer E-C7 SE,Lasting to red &blue light blinking,into paring mode
（noted :Paring need to finish in 5 minutes,after 5 minutes earphone will shut off automatic ）
2.Open the phone or Bluetooth device ,”Bluetooth search”or “add new equipment" search Bluetooth
headset Pioneer E-C7 SE,
3.Click on the device name connection, the connection has a successful connection tone and blue light
flashing. This means that the connection is successful.
二．Answer phone call
incoming call tone or ring tones, short press ( ), you can answer the call.Or use your phone to
answer a call.
三.Reject phone call
Short press ( ) or use the phone to stop the call .
四．Phone call conversion
1.Long press ( ) 3 seconds to transfer calls to the phone .if want to switch back to the headset , just
long press 3 seconds again .
五.Last number redial
Double click ( ) to redial last number
六．Music playing
Short press “ ” paly /pause,long press +to next chart,short press + volume UP;long press -to
previous chart, short press - ,volume down .
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
Loading...