Onkyo AS-1E Owner's Manual
AS-1E –Assembly Instruction Manual–
Thank you for purchasing an Onkyo product!
• This instruction manual describes how to assemble and use the speaker stand and provides precautionary information.
• Be sure to read this manual BEFORE you assemble the stand to ensure proper use of the product.
• Store this manual in a safe place for future reference to help extend the useful life of the product.
• Onkyo cannot guarantee product quality unless you follow the instructions in the manual to assemble the stand.
Precautions before unit assembly
•Have a Phillips screw driver (large or medium) available.
• Assemble the product on a carpet or mat so that the
floor and/or the stand will not become scratched or
damaged.
• Before starting assembly, make sure that you have all
the parts by referred to in the parts list and assembly
diagram.
• Be careful not to scratch the speaker when you install
the speaker on the speaker stand.
Dimensions
4-15/16"
23"
22"
Package contents
• Spike
• Speaker affixing screw • Teflon washer
• Screws for additional
top panel
Finished assembly
* This illustration shows a single unit.
11-5/16"
Product weight: 15.9 lbs (per unit)
Static live load capacity: 44 lbs or less;
* Do not exceed this limit.
16-1/4"
E
n
Assembling the speaker stand
Attach the additional top panel to the original
top panel by inserting and tightening the additional top panel screws in the appropriate screw
holes in accordance with the size of the speaker.
Secure the D-312E speaker to the stand.
Use the speaker affixing screws and teflon washers
to install and secure the speaker to the stand, as
shown in the illustration.
Insert the spikes into the spike holes in the base.
Onkyo recommends that you use the included
spikes for improved sound quality. However, be
aware that spikes may leave scratches or traces on
a wooden floor.
SN 29344352
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved.
Maintenance
To keep the stand clean, occasionally wipe off
dust using a soft dry cloth.
To remove dirt, dilute a neutral detergent (e.g., a
6-to-1 water/detergent solution). Lightly dampen
a cloth using the diluted detergent solution, then
wipe off the dirt. Then, wipe off any detergent
from the surface using a water-soaked cloth.
Finally, wipe the surface using a soft dry cloth.
Do NOT use alcohol or a thinner solvent or allow
the surface to remain wet. Otherwise, the stand
may be deformed or discolored.
I0607-1
* 2 9 3 4 4 3 5 2 *
Loading...