Omega Products UWRH-2A-NEMA-M12-CABLE User Manual

Weather Resistant Wireless Relative Humidity/Temperature Transmitter
UWRH-2A-NEMA-M12,
UWRH-2A-NEMA-M12-CABLE
For Available
Receivers,
Visit omega.com/
wireless
Directional antenna included.
H
u
UWRH-2A-NEMA-M12, wireless relative humidity temperature transmitter includes zTHP2 probe, shown smaller than actual size.
U Transmits Data Wirelessly in Real-Time
U Weather Resistant NEMA 4X (IP65)
Enclosure
U Measures Both Relative Humidity and
Temperature in One Unit
U Low Power Operation and Sleep Mode
For Long Battery Life
U Transmits Relative Humidity, Ambient
Temperature, Signal Strength and Battery Status in Real Time
U Works with Any UWTC Series Wireless
Receivers and Transceivers
OMEGA’s new wireless relative humidity transmitter features a stand-alone, compact, battery powered NEMA design that transmits measurements back to a host receiver up to 120 m (400') away. When activated the wireless transmitter will transmit readings continuously at pre-set time interval that was programmed by the user during the initial setup. Each unit measures and transmits relative humidity reading, ambient temperature, RF signal strength and battery condition to the receiver and is displayed on your PC screen in real time using the provided software. When used with host receiver UWTC-REC1, data from up to 48 wireless transmitters can be received and displayed. Each compatible receiver includes free software that converts your PC into a strip chart recorder or data logger so readings can be saved and later printed or exported to a spread sheet file. When used with host transceiver UWTC-REC2, wireless data from one unit can be re-transmitted out of the receiver by a wired connection as a analog voltage or current signal to interface with a controller, PLC or data acquisition board.
Hu-X
Specifications
Temperature Range: -17 to 49ºC
(2 to 120ºF)
Input Connection: M12 connector Resolution: Relative Humidity Accuracy: ±2.5% RH from
20 to 80% RH; ±3.5% RH below 20 and above 80% RH@ 25°C (76°F)
Operating Environment: -10 to 70°C (14 to 158°F)
Transmit Sample Rate: Programmable from 2 sec to 2 min
Radio Frequency (RF) Transceiver Carrier: ISM 2.4 GHz, direct sequence
spread spectrum
RF Output Power: 10 dBm (10 mW) Range of RF Link:
Outdoor Line of Sight:
Up to 120 m (400')
Indoor/Urban: Up to 40 m (130')
RF Data Packet Standard:
IEEE 802.15.4, open communication architecture
Battery: One 3.6V lithium, “C” cell battery (included)
Battery Life (Typical): 3 year at 1 sample/minute reading rate @ 25°C (77°F)
Data Transmitted to Host: Relative humidity, ambient temperature, RF transmit strength and battery condition
Enclosure: NEMA 4X (IP65) polycarbonate
Dimensions:
145.8 L x 94.7 W x 50.8 mm H (5.74 x 3.73 x 2")
1% RH, 0.1°C (0.1°F)
Range: 2 to 98% RH
USB connection (cable included)
UWTC-REC2 models are available with 4 to 20 mA, 0 to 5 Vdc, 0 to 10 Vdc or Type K thermocouple output. Mating connector and cable included.
included with compatible receiver.
Data logging and recording software
pH
UWRH-2A-NEMA-M12-CABLE, includes zTHP-P probe with cable, shown smaller than actual size.
pH
14 pH
Laptop not included.
To Order Visit omega.com/uwrh-2a-nema-m12 for Pricing and Details
Model No. Description UWRH-2A-NEMA-M12 Wireless RH/temperature transmitter with NEMA enclosure UWRH-2A-NEMA-M12-CABLE Wireless RH/temperature transmitter with NEMA enclosure, cable probe
Receivers/Accessories Model No. Description
UWTC-REC1 USB powered 48-channel transmitter receiver UWTC-REC2-(*) 48-channel receiver with analog output UWTC-REC2-D-(*) 48-channel receiver with analog output and display UWTC-REC3 32-channel wireless receiver with ethernet UWTC-REC4-(*) 48-channel DIN rail receiver with 4 analog outputs and alarms UWTC-REC6-(*) 1-channel transceiver with analog output UWTC-CABLE Spare USB programming/communication cable
UWM-DINRAIL DIN rail mounting bracket assembly
UWTC-BATT-NEMA Replacement 3V C cell Li battery
Comes complete with operator’s manual, probe, antenna, and one 3.6V lithium “C” cell battery.
* Specify analog output signal: “V1” for 0 to 5 Vdc; “V2” for 0 to 10 Vdc, or “MA” for 4 to 20 mA.
Ordering Examples: UWRH-2A-NEMA-M12, wireless RH/temperature transmitter and UWTC-REC1, 48-channel receiver. UWRH-2A-NEMA-M12-CABLE, wireless RH/temperature transmitter and UWTC-REC2-D-MA, 48-channel receiver with
analog output and display.
Hu-X
To Order Visit omega.com/xxxxxx for Pricing and Details
Loading...