Omega Products UWPC-2A-NEMA-M12 User Manual

Weather Resistant Wireless Process Transmitter
Voltage/
Current Transmitter
UWPC-2A-NEMA-M12
U Convert Process Signal
to Wireless—Up to 120 m (400')
U Accepts 0 to 1V, 0 to 5V,
0 to 10V and 4 to 20 mA Signals
U Weather Resistant NEMA
4X (IP65) Enclosure
Sleep Mode for Long Battery Life
U UWTC Receivers Work
with Up to 48 Wireless Transmitters
U Transmit Temperature Data
Wirelessly to a PC or the Internet
U User Selectable Input
Ranges
Directional antenna included.
Convert Your
Pressure Transducer
to a Wireless
Pressure Sensor!
PSU-93, sold
separately.
W
M12C-PUR-4-S-F-2, DC cable assembly, sold separately.
Part of a Complete Wireless System:
• Temperature
• Humidity
• Infrared
The new UWPC wireless process transmitter converts standard process signals (0 to 1V, 0 to 5V, 0 to 10V and 4 to 20 mA) into a wireless signal that can be transmitted up to 120 m (400'), eliminating the need for wiring runs in a variety of environments.
The wall mountable UWPC transmits data at preset intervals, selectable from 2 to 120 seconds. Transmitted data includes the sensor reading, along with RF signal strength and battery status.
The UWPC is compatible with the UWTC-REC family of wireless receivers, which can accept signals from up to 48 wireless transmitters, and display them on a PC.
Each compatible receiver includes free software that converts your PC into a monitor, chart recorder or data logger. Readings can be saved and later printed or exported to a spreadsheet file.
Temperature
• Pressure
• pH
W-X
PX419 pressure transducer, sold separately.
All models shown smaller than actual size.
Add wireless capability to your existing monitoring
equipment. Simply add model UWPC-2A-NEMA-M12
in-line with any two-wire 4 to 20 mA loop system!
UWPC-2A-NEMA-M12
DP24-E
PX419
Typical 2-Wire
4 to 20 mA Loop
System with
Wireless Upgrade
Specifications
Input Range: 0 to 1 Vdc, 0 to 5 Vdc,
0 to 10 Vdc or 4 to 20 mA
Accuracy: ±0.04% of range Input Connection: M12 connector Transmit Sample Rate:
from 1 sample/2 sec to 1 sample/120 sec
Radio Frequency (RF) Transceiver Carrier: ISM 2.4 GHz, direct sequence
spread spectrum
Programmable
RF Output Power: 10 dBm (10 mW) Range of RF Link:
Outdoor Line of Sight:
Up to 120 m (400')
Indoor/Urban: Up to 40 m (130’)
RF Data Packet Standard:
IEEE 802.15.4, open communication architecture
Power: One 3.6V, lithium “C” cell battery (included)
Battery Life (Typical): 3 years 1 sample/minute reading rate @ 25°C (77°F)
Enclosure:
NEMA 4 (IP65), polycarbonate Enclosure Dimensions:
145.8 L x 94.7 W x 50.8 mm H (5.74 x 3.73 x 2")
Resolution: 14-bit, up to 4 decimals
To Order
Visit omega.com/uwpc-2a-nema-m12 for Pricing and Details
Model No. Description UWPC-2A-NEMA-M12 Wireless process input transmitter with NEMA enclosure
Receivers/Accessories Model No. Description UWTC-REC1 USB powered 48-channel transmitter receiver UWTC-REC2-(*) 48-channel receiver with analog output UWTC-REC2-D-(*) 48-channel receiver with analog output and display UWTC-REC4-(*) 48-channel DIN rail receiver with 4 analog outputs and alarms UWTC-REC6-(*) 1-channel transceiver with analog output UWTC-CABLE Spare USB programming/communication cable UWPC-CONN Spare male input connector M12-PUR-4-S-F-2 DC cable assembly for probes, sensors and transmitters PX419 High accuracy pressure transducer micro-machined silicon design PSU-93 DC power supply
UWM-DINRAIL DIN rail mounting bracket assembly UWTC-BATT-NEMA Replacement 3V C cell Li battery
Comes complete with antenna, 3.6V lithium “C” cell battery, and operator’s manual. Note: Because of transmission frequency regulations, these products may only be used in the United States, Canada and Europe (please note
CE compliance of the specific model for use in Europe).
* Specify analog output signal: “V1” for 0 to 5 Vdc; “V2” for 0 to 10 Vdc, or “MA” for 4 to 20 mA.
Ordering Examples: UWPC-2A-NEMA-M12, wireless process input transmitter, UWTC-REC1, USB powered 48-channel transmitter receiver, PX419-005GV, 5 psig high accuracy transducer, M12-PUR-4-S-F-2, DC cable assembly, and PSU-93 DC power supply.
UWPC-2A-NEMA-M12, wireless process input transmitter, UWTC-REC2-MA, 48-channel receiver with analog output, PX419-005GV, 5 psig high accuracy transducer, M12-PUR-4-S-F-2, DC cable assembly, and PSU-93 DC power supply.
Connect a Wireless Receiver to Your Computer, PLC, or Data Logger to Form a Complete Wireless System!
Monitor Up to 48
Different Wireless
Transmitters with One
Receiver!
USB connection (cable included)
UWTC-REC2-V1, shown smaller than actual size. UWTC-REC2 models available with 4 to 20 mA, 0 to 5 Vdc or 0 to 10 Vdc analog output. Mating connector and cable included.
Data logging and recording software included with the compatible receivers.
For Available
Receivers,
Visit omega.com/
wireless
Laptop not included.
W-X
Loading...