3
To Order, Call or Shop Online at
omega.com
SM
SPECIFICATIONS
ANALOG INPUTS
A/D Converter:
OM-USB-1208FS and
OM-USB-1409FS; One
successive approximation
A/D Converter:
OM-USB-1608FS; Eight
successive approximation
A/D converters
Number of Channels:
OM-USB-1208FS and
OM-USB-1408FS;
8 single-ended/ 4 differential:
OM-USB-1608FS;
8 single-ended
Resolution:
OM-USB-1208FS;
12-bit (differential),
11-bit (single-ended):
OM-USB-1408FS;
14-bit (differential),
13-bit (single- ended):
OM-USB-1608FS;
16-bit (single-ended)
Integral Linearity Error:
±1 LSB typical
Differential Linearity Error:
±0.5 LSB typical
Repeatability: ±1 LSB typical
Input Voltage Range for Linear
Operation (Single-Ended Mode):
±10V max
Input Common-Mode Voltage
Range for Linear Operation
(Differential Mode):
-10V min, 20V max
Absolute Maximum Input
Voltage:
OM-USB-1208FS and
OM-USB-1408FS; ±28V max:
OM-USB-1608FS; ±15V max
Input Impedance:
OM-USB-1208FS and
OM-USB-1408FS; 122 kΩ:
OM-USB-1608FS; 100 MΩ min
Throughput:
OM-USB-1208FS and
OM-USB-1408FS; 250 S/s typical
(software paced, PC dependent);
50 kS/s (continuous scan):
OM-USB-1608FS; 500 S/s all
channels (software paced);
100 Ks/s divided by the number
of channels (50 Ks/s max per
channel, scan to PC memory);
200 Ks/s divided by the number
of channels (50 Ks/s max per
channel, burst scan to to 32K
sample FIFO)
OM-USB-1208FS OM-USB-1208FS OM-USB-1608FS
Range OM-USB-1408FS OM-USB-1408FS Single-Ended
Single-Ended Differential
± 20V – ± 11.0 mV –
± 10V – ± 7.3 mV ± 5.7 mV
± 5V ± 11.0 mV ± 3.7 mV ± 3.0 mV
± 4V – ± 2.9 mV –
± 2.5V – ± 1.8 mV –
± 2V – ± 1.7 mV ± 1.3 mV
± 1.5V – ± 1.2 mV –
± 1V – ± 1.1 mV ± 0.7 mV
DC Voltage Ranges and Absolute Accuracy at 25°C (mV, typical)
Channel Gain Queue: Software
configurable channel, range
and gain
Trigger Source:
Software selectable
Pacer Source:
Software selectable
ANALOG OUTPUTS
(OM-USB-1208FS,
OM-USB-1408FS Only)
Number of Channels: 2
Resolution: 12-bit (1 in 4096)
Accuracy: 4.0 LSB or 0.1 %FSR
typical, 45.0 LSB or 0.9 %FSR max
Output Range: 0 to 4.096V
(0 to 4096,1 mV per LSB)
Throughput: 250 kS/s single
channel typical (software paced,
PC dependent); 10 kS/s (single
channel, continuous scan); 5 kS/s
(dual channel, continuous scan,
simultaneous update)
Output Drive:
15 mA per D/A channel
Slew Rate: 0.8 V/us typical
DIGITAL I/O
Number of Digital
I/O Channels:
16 for OM-USB-1208FS and
OM-USB-1408FS); 8 for
OM-USB-1608FS
Type: CMOS
Configuration: Each DIO bit can
be independently configured for
input or output. Power on reset is
input mode.
Pull-Up/Pull-Down Configuration:
All pins pulled up to 5V via 47 kΩ
resistors (default). Pull-down to
ground (GND) also available.
Digital I/O Transfer Rate
(Software Paced): Digital input;
50 port reads or single bit reads per
second (typical): digital output; 100
port writes or single bit writes per
second (typical).
Input High Voltage: 2.0V min,
5.5V absolute max
Input Low Voltage: 0.8V min,
-0.5V absolute min
Output High Voltage: 0.7V max
(IOL = 2.5 mA)
Output Low Voltage: 3.8V min
(IOH = -2.5 mA)
COUNTER
Number of Channels: 1
Resolution: 32-bit
Counter Type: Event counter
Input Type: TTL, rising edge
triggered
Schmitt Trigger Hysteresis:
20 mV to 100 mV
Input Leakage Current:
±1.0 uA typical
Input Frequency: 1 MHz max
High Pulse Width: 500 ns min
Low Pulse Width: 500 ns min
Input High Voltage: 4.0V min,
5.5V absolute max
Input Low Voltage: 1.0V max,
-0.5V absolute min
EXTERNAL TRIGGER
Source: External digital
Mode: Software selectable
Latency: 10 us max
Pulse Width: 1 us min
Input High Voltage: 4.0V min,
5.5V absolute max
Input Low Voltage: 1.0V max,
-0.5V absolute min
Input Leakage Current: ±1.0 uA
EXTERNAL CLOCK
INPUT/OUTPUT
Pin Name: SYNC, software
selectable direction (bidrectional);
output (default), outputs internal A/D
pacer clock; input, receives A/D
pacer clock from external source
Input Clock Rate: 50 KHz max
Clock Pulse Width: 1 us min (input
mode), 5 us min (output mode)