3
ANALOG INPUT CALIBRATION
Calibration Method:
Factory calibration
Calibration Interval: 1 year
TRIGGERING
Mode External Digital via
DTRIG (Pin 76): Software
configurable for rising or falling edge
External Analog via ATRIG
(Pin 78): See external
analog trigger
Multi-Channel Analog
(OM-LGR-5327, OM-LGR-5329):
Level-sensitive based on acquired
data. Up to 16-channels may be
used as independent trigger
sources.
Digital Pattern Trigger
(OM-LGR-5327, OM-LGR-5329):
Trigger when a user-defined 1 to
16 bit digital pattern is matched on
the DIN0-DIN15 pins.
Programmable mask bits.
External Digital Trigger Latency
Non-Pretrigger Acquisition:
100 ns typical, 1 µs max
Pretrigger Acquisition: 1 scan
period max
External Trigger Pulse Width:
1 µs min
Internal Trigger Latency:
2* (1/per-channel sample rate)
EXTERNAL ANALOG TRIGGER
External Analog Trigger Source:
ATRIG input (pin 78)
Analog Trigger Input Ranges:
OM-LGR-5325: ±10V;
OM-LGR-5327, OM-LGR-5329:
±30 V, ±10V, software selectable
Absolute Maximum Input Voltage
OM-LGR-5325: ATRIG_IN to
AGND, ±25V max (power
ON/OFF);
OM-LGR-5327, OM-LGR-5329:
ATRIG_IN to AGND, ±38V max
(power ON/OFF)
Input Impedance
OM-LGR-5325: ±10V range,
10 GΩ (power ON), 1 kΩ
(power OFF);
OM-LGR-5327, OM-LGR-5329:
±30V range, 1 MΩ (power ON),
1 GΩ (power OFF); ±10V range,
10 GΩ (power ON), 1 GΩ
(power OFF)
Trigger Modes: Configurable for
positive or negative slope, level
Trigger/Hysteresis Resolution:
12 bits, 1 in 4096
Trigger/Hysteresis Levels:
±10V/4096 or ±30V/4096,
software selectable
Trigger/Hysteresis Accuracy:
±2% of reading, ±50 mV offset
Latency: 1.5 µS
Full Power Bandwidth (-3 dB):
1 MHz
DIGITAL INPUT
Number of Inputs: 16-channels
OM-LGR-5325
Input Type: TTL
Input Voltage Range: 0 to 28V
Input Characteristics: 47 kΩ
pull-down resistor, 39.2 kΩ
series resistor
Max Input Voltage Level:
0 to +32V (power ON/OFF)
Min High Level Input Voltage
Threshold: 2.0V max
Max Low Level Input Voltage
Threshold: 0.8V min
OM-LGR-5327
Input Type: TTL
Input Voltage Range: 0 to 28V
Input Characteristics: 47 kΩ
pull-down resistor, 39.2 kΩ series
resistor
Max Input Voltage Level:
0 to 32V (power ON/OFF)
Min High Level Input Voltage
Threshold: 2.0V max
Max Low Level Input Voltage
Threshold: 0.8V min
Event Logging: Change of state,
pattern recognition; event time
stamped using real time clock
OM-LGR-5329
Input Type: Industrial
Input Voltage Range: 0 to 30V
Input Characteristics: Resistor
divider 39.2 kΩ series resistor
and 10 kΩ shunt resistor connected
to IGND
Max Input Voltage Level: 36V
(power ON/OFF)
Min High Level Input Voltage
Threshold: 10.04V max
Max Low Level Input Voltage
Threshold: 3.85V min
Event Logging: Change of state,
pattern recognition; event time
stamped using real time clock
Isolation: 500 Vdc min
DIGITAL OUTPUT
Number of Outputs: 1
Type: Mechanical relay, NEC
ED2/EF2 series
Relay Configuration: 1 Form C
Relay Contact Resistance:
0.075 Ω
Relay Contact Operate Time:
3 mS (excluding bounce)
Relay Contact Release Time:
2 ms (excluding bounce)
Relay Insulation Resistance:
1000 MΩ at 500 Vdc
Relay Contact Ratings
Max Switching Voltage:
220 Vdc/250 Vac
Max Switching Current: 1.0 A
Max Carrying Current: 2.0 A
COUNTERS
OM-LGR-5325
Counter Type: Conventional
Number of Channels: 4
Inputs: Counter, Up/Down, Gate
Resolution: Fixed 32-bit or as sized
by the modulo register
Count Modes: Up/down,
period/frequency, Modulo n
OM-LGR-5325
OM-LGR-5327
OM-LGR-5329
To Order, Call or Shop Online at
omega.com
SM