Omega Products MMI-01 User Manual
OperatOr Interface
125 (4.90)
125 (4.90)
35
(1.38)
3 (0.13)
98 (3.875)
CENTERED
98 (3.875)
CENTERED
123
›
›
456››
789
YES NO
.0
SPACE BKSP ENTER
76 (2.988)
50 (1.975)
11 (0.425)
24 (0.963)
24 (0.960)
DIsplay Messages, change MOtIOn
paraMeters “On the fly”
MMI-01
l Ideal Operator Interface for
Si Programmable Drives
l Connects Directly to
Programmable Drives Using the
Standard Programming Cable—
No Special Wiring Required
l Power is Supplied by the Drive—
No Additional Power Supply
Required
l Easy to Program Using Simple
Indexer
TM
Programmer Software
l 4-Line, 20 Character/Line
LCD Display
l 20 Key Keypad
l NEMA 4/12 (IP56/52) Rating
(Dustproof and Drip Proof When
Properly Mounted)
l Can be Surface Mounted or Flush
Mounted [NEMA 4/12 (IP56/52)
Rating for Flush Mounting Only]
MMI-01 shown smaller
than actual size.
The MMI-01 is an easy-to-use, flexible
device that allows an operator to enter move
speeds, move distances or repeat loop counts.
Messages can also be displayed and the
program can be paused until the user presses
a key, such as ENTER, YES or NO. Program
branching can be accomplished based on
the response of YES or NO. The MMI-01 is
compact, easy to install and carries a
NEMA 4/12 (IP56/52) rating (The 4 x 20
character display and 20 key membrane
keypad are sealed). Connection to any of our
“Si” or “i” indexer drives is accomplished by the
standard programming cable that is supplied
with every drive. This cable also supplies
power to the MMI-01 so that no additional
power supply or wiring is needed. Set-up
and programming of the MMI-01 is fast and
easy. Our programmable “Si” or “i” drives are
furnished with Si Programmer software, which
allows the user to easily program instructions
for the terminal. Complex, confusing items
like baud rate, parity and cursor positioning
are handled automatically by the software.
On screen emulation of the MMI-01 by the Si
Programmer software allows a potential user
to try the MMI before purchasing one.
Dimensions: mm (inch)
prOgraMMIng
l Easy to Program Using Si
ProgrammerTM Software,
Running on Windows
l Six Functions are Available:
1) Display a Message,
Up to 60 Characters
2) Display a Message and
Pause Program Until
Operator Presses
ENTER Key
3) Display a Message, Wait
for Operator to Press YES
or NO Key, Branch
Program on YES
To Order Visit omegamation.com/mmi-01 for Pricing and Details
MODEL NO. DESCRIPTION
MMI-01 Operator interface
Ordering Example: MMI-01, operator interface.
D-36
4) Display Message,
Allow Operator to
Enter a Loop Count
5) Display Message,
Allow Operator to
Enter a Speed
6) Display Message,
Allow Operator to
Enter a Distance
l Speeds, Distances and
Loop Counts Entered by the
Operator Can be Stored in Any
of Eight Nonvolatile Memory
Locations for Use in Repeat
Loops and Motor Moves
Loading...