Omega Products CN-TOT-175JF-240 Installation Manual

CN-TOT SERIES

Portable Thermocouple Temperature

Controller

TABLE OF CONTENTS

IMPORTANT SAFETY INSTRUCTIONS

Introduction...................................................................

Safety Alert Symbol.......................................................

Important Safety Instructions……………......................

Specifi cations................................................................

Installation / Operation Instructions.……......................

Programming Instructions.............................................

Troubleshooting Guide……………………………..........

Notes ...........................................................................

Warranty........................................................................

2
2
3
4
4
5
6
7
BACK

INTRODUCTION

OMEGALUX® CN-TOT Portable Thermocouple Temperature Controllers
are designed for general purpose use in indoor environments to control the
temperature of small tanks, drums, pipes, or other applications requiring
automatic control.

SAFETY ALERT SYMBOL

Immediate hazards which WILL result in severe
personal injury or death

The symbol above is used to call your attention
to instructions concerning your personal safety.
It points out important safety precautions. It
means “ATTENTION! Become Alert! Your
Personal Safety is involved!” Read the
message that follows and be alert to the
possibility of personal injury or death.

Hazards or unsafe practices which COULD result in
severe personal injury or death

A person who has not read and
understood all installation instructions
is not qualifi ed to install this product.

• Do not immerse controller in liquid.

• Keep volatile or combustible material away from

controller when in use.

• Use controller only in approved locations.

• Keep sharp metal objects away from controller.

Failure to observe these warnings may result in
electric shock, risk of fi re, and personal injury.

End User Must Comply to the Following:

• Must be mounted vertically for outdoor use

• Only qualifi ed personnel are allowed to connect

electrical wiring.

• All electrical wiring must follow local electrical
codes and highly recommend following NEC
Article 427.

• Final installation / wiring is to be inspected by the
authority who has jurisdication in the area that
the heater and temperature controller is installed.

• The end-user is responsible for providing a
suitable disconnecting device.

• The end-user is responsible for providing
suitable electrical protection device. It is highly
recommended that a ground fault circuit breaker
is used.

Failure to observe these warnings may result in
personal injury or damage to the controller.

• Inspect all components before
use.

• Do not use control and heater if
any component is damaged.

• Do not repair damaged or faulty
controller.

• Do not crush or apply severe
physical stress on any component
of controller, including cord
assembly.

• Power plug must be plugged into
a sheltered outlet.

• Unplug controller when not in use.

• Unplug controller before fuse is

changed.

• Do not change the fuse while
raining or if water can be
splashed into the fuseholder while
the cap is off.

Failure to observe these warnings may
result in personal injury or damage to
the controller.

Hazards or unsafe practices which COULD result in
minor personal injury or property damage.

SAVE THESE INSTRUCTIONS!

Additional copies of this manual are available upon request.

© Copyright 2006 OMEGA ENGINEERING, Inc. All rights reserved. This document may not be copied, photocopied,

2

reproduced, translated, or reduced to any electronic medium or machine-readable form, in whole or in part, without the
prior written consent of OMEGA ENGINEERING, INC

© Copyright 2006 OMEGA ENGINEERING, Inc. All rights reserved. This document may not be copied, photocopied,
reproduced, translated, or reduced to any electronic medium or machine-readable form, in whole or in part, without the
prior written consent of OMEGA ENGINEERING, INC

3