READ AND SAVE THESE INSTRUCTIONS
OPERATION, MAINTENANCE
AND SAFETY INSTRUCTIONS
OP125
Due to ongoing product development, images shown are subject to change without warning
Product Overview
GENERAL SPECIFICATION
DETAILED SPECIFICATION
Parts & Assembly
CARTON CONTENTS
ASSEMBLY INSTRUCTIONS
Useful Information
CLEANING
OSCILLATION
REMOTE STORAGE
Important Safety Instructions
IMPORTANT
Read the safety precautions of this booklet carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply
with instructions could result in personal injury and/or property damage. If you are unsure about anything
regarding your fan or these instructions, please contact Omega Altise on 1300 795 572 in Australia or
(09) 415 6000 in New Zealand before operating your appliance.
1. Read all instructions carefully before using the pedestal fan.
2. Use this pedestal fan only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons. Do not modify this appliance. Do not try to repair
this appliance – there are no user serviceable parts within.
3. Remove the packaging and ensure that the appliance is undamaged (keep packing box for later storage).
In case of doubt do not use the appliance and contact Omega Altise Service. Do not let children play with
any parts of the packaging.
4. Before you use the appliance, check if the voltage marked on the rating label corresponds to the mains in
your home.
5. Do not use this appliance with a programmer, timer or any other device that switches the appliance on
automatically, since a fire risk exists if the appliance is covered or positioned incorrectly.
6. Do not pull the power cord to disconnect with the power source. Always grasp the plug to pull it out.
7. Do not run power cords under rugs, curtains or other combustible materials. Do not place power cords in
areas where they can be a tripping hazard. Do not operate directly below a power outlet.
8. Do not insert any objects into the appliance as it may cause an electric shock or fire or damage to the
appliance. Do not block or tamper with the appliance in any manner while it is in operation. To prevent
a possible fire, do not cover the appliance in any manner. Do not place on soft surfaces, like a bed, where
openings may become blocked.
9. Do not leave the appliance unattended. Always unplug the appliance when not in use. Take care that it is
not obstructed when oscillating.
10. The appliance is only to be used with the power supply unit provided with the appliance.
11. This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user maintenance shall not be made by children without
supervision.
WARNING:
1. Keep materials such as hair, net curtains, tablecloths & clothes away from the openings of the pedestal
fan, as material may be sucked into the appliance causing injury or damage to property or the appliance.
2. The appliance has hot and arcing or sparking parts inside. It must NOT be used in potentially dangerous
locations such as flammable, explosive, chemical-laden, corrosive, salty or wet atmospheres. This
appliance is intended for general indoor domestic use ONLY.
3. This appliance is not intended for use in wet or damp locations. Never locate it where it may fall into a
bathtub or other water container.
4. Do not use the pedestal fan outdoors. Do not use close to windows or in direct sunlight.
5. Always place the appliance on flat, stable surfaces before use. Always place the appliance vertically on its
base.
NOTE: Over time, the grills at the front and rear of the appliance will build up dust & dirt. This should be
cleaned regularly to maintain optimum efficiency. Follow the cleaning procedure within this instruction
WARNING:
The Function Switch should not be used as the sole means of disconnecting
power. Always unplug the power cord before servicing or moving the appliance.
To avoid danger of electric shock, unplug from outlet when not in use and before
cleaning. If the supply cord is damaged, it must be replaced by the manufacturer,
its Service Agent or similarly qualified persons in order to avoid a hazard. In order
to avoid overheating, do not cover the appliance. Do not use the appliance in the
immediate surrounding of a bath, shower or swimming pool
MODEL:
Rated Voltage:
Rate Power Input:
Product Dimensions - Base (mm):
Product Dimensions - Head (mm):
Weight:
OP125B - Blue
OP125BLK - Black
OP125M - Mint
OP125W - White
24VDC
30w
1255h x 700w x 700d
1255h x 325w x 215d
5kg
5-6
Setting Position (Speed)
dB(A)
Meters per second
Max fan flow rate
Tested according to clause 9 of IEC60879:1986 (corr.1992) at client specified setting positions
High Range
71.1 64.7 61.1
5.8 4.5 3.9
16.83 13.01 11.39
3-4
Mid Range
Low Range
1-2
1) Fan Assembly x 1pc 2) Base x 1pc 3) Screw M4*30 x 3pcs 4) AC/DC Adapter x 1pc
5) Remote Control x 1pc 6) Remote Control
Bracket x 1pc
STEP 1: ATTACH BASE TO STAND
7) Screw Driver x 1pc 8) CR2032 Battery
4.1 ASSEMBLY INSTRUCTIONS CONT.
STEP 2: INSERT AC/DC ADAPTER
STEP 3: SYNC REMOTE TO FAN
1. Turn on the fan
2. 2. Remove protective film strip from remote to activate battery
• If no battery, please insert a new one (CR2032)
3. Press and hold the power button and oscillation buttons for 5 seconds
• Remote will now sync, if unsuccessful, repeat this step
Cleaning should be performed periodically to ensure the longevity of your new fan.
• Ensure the fan is disconnected from the power
• Take a clean microfiber cloth
• Wipe rear and front guard until clean
Oscillation can be set by the remote control, refer to step 3 for operation instructions.
There are two forms of oscillation associated with the AURA:
• Left/right - maximum range is 80° ± 2°
• Up/down - maximum range is 40° ± 2° (Manual Configuration only)
• Remote can be stored in the rear guard when the fan is off for discrete storage.
• When fan is operating, remote can be stored in holder. Holder can be attached to the
stand pole.
Do not store remote control in the rear guard whilst the fan
is in use.
Rear Guard Storage Remote Holder (while fan is in use)
It is important that you retain these instructions, proof of purchase as well as other
important documents about this product for future reference. Due to continual
product development, Omega Altise reserves the right to alter specifications or
Dispose of packaging responsibly - recycle where facilities are available.
appearances without notice.
A division of Shriro Australia Pty Ltd
104 Vanessa St Kingsgrove NSW 2208
In Australia: 1300 795 572
In New Zealand: (09) 415 6000
www.omegaaltise.com.au
Loading...