Omega OAPC10 User Manual

USER’S MANUAL

PORTABLE AIR CONDITIONER

TECHNICAL SPECIFICATION

MODEL : OAPC10

Voltage : 220-240V~ 50Hz Power consumption: 890W

IMPORTANT SAFEGUARDS

Please read this manual

Inside you will find many helpful hints on how to use and maintain your air

conditioner properly. Just a little preventative care on your part can save you a

great deal of time and money over the life of your air conditioner. You will find

many answers to common problems inside this manual.

CAUTION

• Contact the authorised service centre for repair of this unit

• This air conditioner is not intended for use by young children or infirm persons,

without

• Supervision.

• Young children should be supervised to ensure that they do not play with the

appliance

• If the power cord is damaged it must be performed by an authorised agent of

Omega Altise

SAFETY RULES

To prevent injury to the user or other people and to prevent property damage,

the following instructions must be followed. Incorrect operation due to not

reading the instructions may cause harm or damage.

• Your air conditioner should be used in such a way that it is protected from

moisture (eg splashed condensation water) do not store or place the air

conditioner where it can fall or be pulled into water.

• Always transport the air conditioner in a vertical position and stand it on a

stable, level surface during operation.

• Turn off the product when not in use.

• Always contact an authorised qualified person to carry out repairs.

• If the supply cord is damages it must be repaired by a qualified repairer

• Keep the are clear around the appliance. There needs to be a air path of at

least 30cm all around the unit from walls, furniture and curtains.

• If the air conditioner is knocked over during use turn off the unit and unplug it

from the powerpoint.

• Do not operate the air conditioner in a wet room such as a bathroom or laundry

• Do not touch the unit with wet hands

• Do not press buttons on the console with anything but fingers.

• Do not remove fixed covers. Do not use this appliance if it is malfunctioning or

has been dropped or damaged

• Never use the power point switch to start or stop the unit. Use the control

panel first.

• Do not obstruct the inlet or outlet grill

• Do not use harsh chemicals to clean the air conditioner

• Do not run the unit near dangerous chemicals or insecticides or petrol

• Do not use this appliance for functions other than those described in this

instruction manual.

ENERGY SAVING

• Use the appliance in the recommended room size

• Locate the unit where furniture cannot obstruct air flow

• keep blinds and curtains closed to keep out the sun

• Keep the filters clean

• Keep doors and windows closed to keep cool air in and hot air out

Placement

Placement and Installation

Place the machine on flat and dry ground, and keep at least 30 cm from walls etc

(figure 1)

FIGURE 1

Installation

• Spin adapter into exhaust pipe first, then spin the exhaust pipe into exhaust

connector (counter-clockwise) (figure 2)

• Put adapter into window seal plate, adjust window open width in order seal

plate match window well, and the length of seal plate is adjustable.

FIGURE 2

Installation Errors

• Free access of exhaust pipe is important, If air is not taken out it will affect

performance of the appliance.

• Avoid sharp bends in the exhaust-pipe (figure 3)

Make sure air in exhaust pipe can run smoothly (figure 4)

+ 8 hidden pages