Omcan Food Machinery PA10620 Installation Manual
INSTALLATION
Take out the Chip Dump from t he packaging and locate the unit on a firm
level surface. Remove coating from the unit.
When this appliance is to be positioned in close proximity to a wall,
partitions, kitchen furniture, decorative finished, etc., it is recommended that
they be made of non-c ombustible material, if not, they shall be clad with a
suitable non-combustible heat-insulating material, and that the closet
attention be paid to fire prevention regulations.
Once the Chip Dump has been placed in position by consulting International
Standards and regulations. The Unit is ready to operate.
OPERATION
Plug in the Power, switch on the switch, The element starts heating and the
green light is on. When not using, just simply switch off the switch and pull
off the power.
SAFETY
If the power cord is damaged, it must be replaced by qualified technician.
DO NOT TOUCH THE UP HEATER WHEN THE UNIT IS
WORKING, BECAUSE IT IS TOO HOT!
MAINTENANCE
Clean using warm soapy water after each use.
Do not immerse completely in water to clean.
The appliance is not to be cleaned with a water jet.
HELP
If the Chip Dump does not work, please check the following:
1.The power supply is correct and switched on.
2.The positions of switches are correct.
3.The elements are clear.
ELECTRIC COUNTER TOP CHIP DUMP
USER’S GUIDE
BASIC SPECIFICATION
Model Voltage Power Dimension
PA10620 110V/60Hz 8 50W 335(W) X 565(D) X 505(H)
EXPLOSION GRAPH
indicator light
swi t ch
indicator light
pl ug & l ead
el ement
safety grill
body
pan
pl at e
foot
ELECTRICAL DIAGRAM
L
POWER SWITCH
E
N
220- 240V
LIGHT
ELEMENTELEMENT
I NDI CA T OR L I GHT
Loading...