Omcan Food Machinery PA10172 Installation Manual

SAFETY

Please take notice that the unit will still be too hot to handle immediately after use.

The Contact Grill has a thermal cut-off safety device to avoid over heating.

If the power cord is damaged, it must be replaced by qualified technician.

MAINTENANCE

Be sure to always wash the grill plates after each use to remove any residue that may have accumulated.

For cleaning cast iron plate, please use warm soapy water while still warm. Do not use cold water on hot plate.

After cleaning, be sure the oil tray must be dry thoroughly before putting them back to the unit.

Do not immerse completely in water or any liquid to clean. The appliance is not to be cleaned with a water jet.

HELP

If the Omcan Contact Grill does not work, please check the following:

1.The power supply is correct and switched on.

2.The positions of switch and thermostat are correct.

ELECTRIC COUNTER TOP

CONTACT GRILL

USER’S GUIDE

BASIC SPECIFICATION

Model Voltage Power Dimension

PA10170 120V/60HZ 1800W 300(W) X335(D) X 260(H) PA10171 PA10172

EXPLOSION GRAPH

INSTALLATION

Take out the Omcan Contact Grill from the packaging and locate the unit on a firm level surface.

When this appliance is to be positioned in close proximity to a wall, partitions, kitchen furniture, decorative finished, etc., it is recommended that they be made of non-combustible material, if not, they shall be clad with a suitable non-combustible heat-insulating material, and that the closet attention be paid to fire prevention regulations.

Once the Contact Grill has been placed in position by consulting International

Standards and regulations. Cleaning the cast iron plate thoroughly is advised. Warm up the cast iron plate for 10 minutes until all smoke and/or odor has dissipated. Switch off and unplug the unit, then use warm, soapy water to clean.

NEVER USE COLD WATER ON THE HOT PLATE.

ELECTRICAL DIAGRAM

THERMAL CUT OUT

THERMOST AT

SWITCH

120V

I NDI CAT OR L I GHT

ELEMENT

OPERATION

Always preheat the grill before use until the ready light illuminates.

Lift the top grill plate, arrange food on the bottom plate and bring top plate back down to make contact with food and begin cooking. If additional sandwiches are desired. Lower the lid to preserve the heat while you prepare the additional sandwiches. When not cooking, the thermostat is turned off, unplug the unit.