Ohsung Electronics URCZR2 User Manual
http://www.emc2000.co.kr
FCC TEST REPORT
Report No.: EMC-FCC-R0066
EMC compliance Ltd. Page: 1 of 1
480-5 Shin-dong, Yeongtong-gu, Suwon-city, Gyunggi-do, 443-390, Korea
82 31 336 9919 (Main) 82 31 336 4767 (Fax)
This test report shall not be reproduced except in full, Without the written approval.
Appendix 6.
User manual
ZR-2 Repeater Owner’s Manual ©2012 Universal Remote Control, Inc.
The information in this manual is copyright protected. No part of this
manual may be copied or reproduced in any form without prior written
consent from Universal Remote Control, Inc.
UNIVERSAL REMOTE CONTROL, INC. SHALL NOT BE LIABLE FOR
OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS
MADE IN THIS MANUAL.
The information in this manual may be subject to change without prior
notice.
URC - Control the Experience is a registered trademark of Universal
RemoteControl, Inc.
All other brand or product names are trademarks or registered trademarks
of their respective companies or organizations.
ZR-2 REPEATER
Page 1
Introduction
Thank you for purchasing the ZR-2 Repeater. The ZR-2 is used to extend
the operational range between Total Control products that work on URC’s
2.4 GHz RF network, such as the TRC-780 and to the MRX Advanced
System Controller. Once joined to an MRX, it wirelessly repeats
communication between a Total Control remote and an MRX Advanced
System Controller.
Features and Benefits
Wirelessly extend the range between TC 2.4 GHz products
Additional ZR-2 Repeaters can be joined to extend the RF signal to every
corner of the home, or small office.
Compact size allows for easy installation
Seamless integration with the Total Control System
Parts Guide
The ZR-2 Repeater includes:
1 - ZR-2 Repeater
1 - Owner’s Manual
ZR-2 Front and Rear Panel Descriptions
The front and rear panel consists of:
Power LED: When illuminated this light indicates the ZR-2 is powered.
Status LED: The LED shows the RF signal strength between the ZR-2 and
the MRX Advanced System Controller. Pressing the Test buttonon the rear
of the unit refreshes the signal strength.
When the LED is:
OFF: There is no signal to communicate between Total Control
products. Press the Test button to reconnect to the MRX Advanced
System Controller.
Orange: Poor signal strength. URC recommends relocatingthe unit for
strong signal reception.
Green: Receiving optimal signal strength.
Data LED: The Data LED flashes as the ZR-2 Repeater transmitsdata.
Test: Press to obtain the current signal strength status between the ZR-2 and
the MRX Advanced System Controller.
USB: INSTALLER ONLY!! Used for updating the unit’s firmware.
ZR-2 REPEATER
Page 2
POWER LED
STATUS LED
USB
TEST
DATA LED
Specifications
RF Frequency: 2405 ~ 2480 MHz(Two-way RF)
Effective Range: Typically 50-75 ft, depending on environment
Size: L x D x H = 2.559" x 0.984" x 1.968"
Weight: 2 oz.
Power Supply: 100 ~ 240V~, 50/60Hz, 0.3A
USA Limited Warranty Statement
Your Universal Remote Control, when delivered to you in new condition,
is warranted against defects in materials or workmanship as follows:
UNIVERSAL REMOTE CONTROL, INC. warrants this product against
defects in material or workmanship for a period of one (1) year and as set
forth below. Universal Remote Control will, at its sole option, repair
theproduct using new or comparable rebuilt parts, or exchange the product
for a comparable new or rebuilt product. In the event of a defect, these are
your exclusive remedies.
This Limited Warranty covers only the hardware components packaged
with the Product. It does not cover technical assistance for hardware or
software usage and it does not cover any software products whether or not
contained in the Product; any such software is provided "AS IS" unless
expressly provided for in any enclosed software Limited Warranty.
ZR-2 REPEATER
Page 3
500 Mamaroneck Avenue, Harrison, NY 10528
Phone: (914)835-4484 FAX: (914) 835-4532
www.universalremote.com
OCE-0133A Rev 01
275
55
70
Loading...