Ohsung Electronics URCZR1N Users Manual

G

Order Number

: GETEC-C1-11-239

FCC Part 15 subpart C

Test Report Number

: GETEC-E3-11-122 Page 1 / 1

APPENDIX H

: USER’S MANUAL

EUT Type: Zigbee Repeater

FCC ID.: OZ5URCZR1N

ZR-1N Z Repeater

Owner’s Manual

ZR-1N Z Repeater Owner’s Manual ©2010 Universal Remote Control, Inc.

The information in this manual is copyright protected. No part of this manual
may be copied or reproduced in any form without prior written consent
from Universal Remote Control, Inc.

UNIVERSAL REMOTE CONTROL, INC. SHALL NOT BE LIABLE FOR OPER­ATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS MADE IN
THIS MANUAL.

The information in this manual may be subject to change without prior notice.

URC - Control the Experience is a registered trademark of Universal Remote
Control, Inc.

All other brand or product names are trademarks or registered trademarks
of their respective companies or organizations.

500 Mamaroneck Avenue, Harrison, NY 10528

Phone: [phone] Fax: [phone]

TABLE

OF CONTENTS

Introduction 1

Features and Benefits 1

Parts Guide 1

ZR-1N Front and Side Panel Descriptions 2

Specifications 3

USA Limited Warranty Statement 3

Federal Communication Commission

Interference Statement 5

Regulatory Information to the user 6

Declaration of Conformity 7

Page 1

ZR-1N Z REPEATER

Introduction

Congratulations on your purchase of the ZR-1N Z Repeater! The ZR-1N
is used to extend the operational range between Total Control products
such as the TRC-780 and the MRX-10. Once joined to the MRX-10 it
will wirelessly relay communication between an TRC-780 and another
ZR-1N repeater.

Features and Benefits

Wirelessly extends the range between Total Control products. Extend the
operational range between a TRC-780 remote and a MRX-10 Advanced
Network System Controller. Control lighting, music and more from through­out the home.

Parts Guide

The ZR-1N Z Repeater includes:

1 - ZR-1N Z Repeater 1 - AC Power Adapter
1 - Wall Mount and 4 Screws 1 - Owner’s Manual

Page 2

ZR-1N Z REPEATER

ZR-1N Front and Side Panel Descriptions

The front panel consists of 3 indicator lights which will illuminate
when in use.

Power LED: Indicates that the ZR-1N is powered on when illuminated.

Status LED: The LED will show what the RF signal strength of the
ZR-1N to the MRX-10. By pressing the TEST button on the side of
the unit, it will indicate the signal strength. When the LED is:

. OFF: The ZR-1N is not testing for signal strength, and the

TEST button should be pressed.

. Orange: The signal strength is LOW, and the ZR-1N should be

move to a different location

. Green: The signal strength is GOOD, and the ZR-1N is in a

good location.

Data LED: The LED will flash RED when the unit is transmitting or
receiving data.

Antenna: Omnidirectional antenna. Adjust the antenna for best per­formance. Usually vertical positioning works well.

DC9V Power: Attach the included 9V DC power supply here.

Mounting Plate: May be attached to a wall or other surface with the
included screws for easy slide on/off mounting.

POWER

LED

STATUS

LED

USB

DC9V
Power

TEST

Mounting
Plate

Antenna

DATA

LED