Ohio Steel FB-ATV User Manual

Repair Parts List Model No. FB-ATV

CAUTION: READ AND FOLLOW ALL SAFETY

INSTRUCTIONS BEFORE USING

FB-ATV

THIS EQUIPMENT.

FLATBED ATV DUMP CART

ASSEMBLY MANUAL AND PARTS LIST

LIMITED ONE-YEAR WARRANTY

If this product fails due to a defect in material or workmanship within one year from the date of purchase, we will at our option repair or replace it free of charge. This warranty excludes tires and wheels, which are expendable and become worn during normal use. This warranty does not cover:

Repairs necessary because of operator abuse or negligence.

• Equipment used for commercial or rental purposes.

•

Proof of Purchase Required

For

All

Warranty Claims.

Standard hardware items can be purchased locally.

For missing parts or questions call 1-800-652-2321

ORDERING INFORMATION

After the one year warranty period all parts maybe ordered by calling When ordering repair parts, always give the following information:

Product -

• Model Number -

• Part Number -

• Part Description -

•

1-800-652-2321.

TOOLS REQUIRED

3/4" WRENCH AND SOCKET 9/16" WRENCH AND SOCKET PLIERS

SAFETY INSTRUCTION

DO NOT CARRY PASSENGERS IN CART. DO NOT TOW CART ON PUBLIC ROADS. NEVER EXCEED LOAD CAPACITY - 1000LBS. AVOID SUDDEN TURNS OR MANEUVERS. WHEN OPERATING ON SLOPES, USE LOWEST GROUND SPEED AND LIMIT LOAD TO 200LBS. OPERATE UP AND DOWN SLOPES, NEVER ACROSS THE FACE.

FRONT SUPPORT

1/2" X 2-3/4" HEX BOLT

1/2" HEX NUT

1/2" LOCK WASHER

MAINTENANCE

CHECK TIRE PRESSURE REGULARLY

(5 PSI RECOMMENDED.) GREASE WHEELS AT AXLE FOR LONGER LIFE. PERIODICALLY CHECK ALL BOLTS. KEEP CART CLEAN TO PREVENT RUST. STORE INSIDE A CLEAN DRY AREA.

NOTE: DO NOT TIGHTEN BOLTS AT THIS TIME. THEY WILL BE TIGHTENED AFTER AXLE AND WHEELS HAVE BEEN INSTALLED IN A LATER STEP.

3/8" X 3/4" HEX HEAD BOLT

BED ASSEMBLY

AXLE HOLDER PLATE

STEP 1.

Lay cart bed upside down to install axle holder plates.

•

Add four axle holder plates to undercarriage plate, as shown, with eight 3/8" x 3/4" hex bolts,

• and 3/8" lock nuts.

Loosely bolt together the axle holder plates with eight 3/8" x 3/4" hex bolts and 3/8" lock nuts.

•

NOTE: DO NOT TIGHTEN AT THIS TIME.

3/8" LOCK NUT

1/2" FLAT WASHER

STEP 2.

Place front support assembly onto front of cart, as shown.

•

Insert two 1/2" x 2 1/2" hex bolts through front support angle holes, and holes in

• cart bed tube.

Secure in place with two 1/2" flat washers, two 1/2" lock washers, and two 1/2"

• hex nuts.

SPACER

HAIR PIN

HITCH

FRONT SUPPORT

AXLE

COTTER PIN

STEP 3.

Slide axle through axle holder plates, add spacer, drawbar, add another spacer then

• through other set of axle plates.

Center axle and add another spacer, axle washer, tire, axle washer, in that order to

• each side and secure in place by adding cotter pin in axle and spreading ends.

Insert drawbar pin through front support assembly and drawbar, lock in place with

• hair pin.

At this time, tighten ALL bolts.

•

NOTE: TIGHTEN ALL BOLTS.

ATV TIRE