Ohio Steel 50SWP26 Owner’s Manual

50SWP26

26 cu ft LAWN SWEEPER

U.S. Patent No. 7,610,646

_ _ READAND FOLLOWALLSAFETYRULESANDOPERATING _

INSTRUCTIONS BEFORE USING THIS EQUIPMENT

6000235- REV D 3/11

Safety Rules

This is the safety alert symbol. It is used to alert you to

A

Read and understand all safety rules and operating instructions before using this

tractor attachment.

Follow all safety rules and operating instructions provided by your tractor's
manufacturer when using attachment.

Never allow children or untrained persons to operate tractor or attachment.
Reduce tractor speed to slowest setting when towing or operating on slopes.
Operate up and down slopes, never across the face of slopes.

potential personal injury hazards, Obey all safety messages

that follow this symbol to avoid possible injury or death,

Do not carry passengers on tractor or attachment.

Avoid sudden turns or maneuvers.

Use caution when backing up to prevent damaging attachment.
Do not tow attachment on public roadways.
Do not remove warning decals from product.
Check product for worn, loose, or damaged parts before each use. If any damage

is present, repair the product before using.
Check product for loose or missing fasteners before each use. Tighten or replace

fasteners as needed before using.

Do not fasten rope to any part of your body or clothing.
Do not hold rope while tractor and Lawn Sweeper are in motion.

Do not use Lawn Sweeper near fire or smoldering debris.
Always fasten rope to tractor to avoid contact with wheels and brushes.
Always empty hopper before storing to avoid spontaneous combustion of contents.

Do not exceed tractor speed of 6 miles per hour when towing or operating Lawn

Sweeper.

42 (x2)

Carton Contents

(xl)

45 (xl)

39 (xl)

31 (x2)

6 (x2)

4_9 (x2)

50 (x2)

(x2)

3(xl)

53 (x2)

/

26 (x2)

17 (xl)

38(x8)

27 (x4)

30 (x2)

32 (x3)

TOOLS REQUIRED FOR ASSEMBL Y:

• 9/16" Wrench and Socket

54 (x2)

60 (x4)

2

28 (xlO)

29 (xl 1)

Assembly Instructions

11

Attach Short Hitch Tubes to Sweeper Assembly and tighten hardware.

DO NOT OVERTIGHTEN.

_ Attach Handle to Height Adjustment and tighten hardware.

27

Insert Long Hitch Tubes into Short Hitch Tubes and snap into position.

3

Assembly Instructions

Install hardware through front two holes of Long Hitch Tubes as shown.
Hold Adjustment Lever in position and install third bolt as shown.
Pin Adjustment Lever to Handle.

DO NOT TIGHTEN

AT THIS TIME.

28

_ Install Clevis Bars as shown; Clevis bolts pass between Hitch Tube bolts.

Tighten Hitch Tube hardware first, then tighten Clevis hardware.

Insert Bottom Frame Tubes into Rear Frame Tube and snap into position.

41

4O

4