Ohio Steel 3048H-ATV User Manual

5. Refer to repair parts list below. Attach hitch bracket to drawbar with two 3/8" x 3/4" hex bolts and keps nuts as shown. Insert hitch pin and lock in place with hairpin provided.

REPAIR PARTS LIST

* denotes standard hardware item, can be purchased locally.

CAUTION: READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS BEFORE USING THIS EQUIPMENT.

3048HATV

12 CU. FT. HEAPED CAPACITY

ALL TERRAIN CART

ASSEMBLY MANUAL AND PARTS LIST

2575 FERRIS ROAD COLUMBUS, OHIO 43224-2597

3048HATV-REV-N/C 5/04

TOOLS REQUIRED

7/16" WRENCH AND SOCKET 9/16" WRENCH AND SOCKET PLIERS

STEP 1.

FRONT SUPPORT

BACKING PLATE

SAFETY INSTRUCTION

DO NOT CARRY PASSENGERS IN CART. DO NOT TOW CART ON PUBLIC ROADS. NEVER EXCEED LOAD CAPACITY - 1000LBS. AVOID SUDDEN TURNS OR MANEUVERS. WHEN OPERATING ON SLOPES, USE LOWEST GROUND SPEED AND LIMIT LOAD TO 200LBS. OPERATE UP AND DOWN SLOPES, NEVER ACROSS THE FACE.

MAINTENANCE

CHECK TIRE PRESSURE REGULARLY. PERIODICALLY CHECK ALL BOLTS. KEEP CART CLEAN TO PREVENT RUST. STORE INSIDE A CLEAN DRY AREA.

3/8" KEPS NUT

3/8" HEX BOLT

AXLE HOLDER PLATES

3/8" KEPS NUT

FRONT SUPPORT

WELDMENT

1. Attach front support and front support backing plate to cart body as shown with three 3/8" x 3/4" hex head bolts and 3/8" keps nuts.

3/8" HEX BOLT

COTTER PIN

AXLE

TIRE

AXLE WASHER

AXLE SPACER

STEP 2.

2. Loosely attach the four axle holder plates with the 3/8"x 3/4" hex head bolts provided. NOTE: these bolts will be tightened after axle and wheels are installed in a later step.

DRAWBAR

STEP 3.

3. Center drawbar tube between axle holder plates and insert axle, making sure to center axle so that wheels can be put on in the next step.

AXLE SPACER

AXLE WASHER

STEP 4.

COTTER PIN

4. Slide axle washer and axle spacer over each side of axle as shown. Add wheels making sure valve stem faces out. Insert cotter pin in axle and lock in place by spreading ends. Turn cart upright and add tailgate.