ODL Reduced Travel Unit Maintenance Manual
Reduced Travel Unit
Easy to add on. No drilling into door.
Las instrucciones en
español comienzan en
la página 6
La traduction française
est sur la page 10
INSTALLATION/MAINTENANCE INSTRUCTIONS
For full view and half view sizes.
ENCLOSED TREATMENT INSTALLATION INSTRUCTIONS
Thank you for your purchase of ODL enclosed treatment. Unpack your
lind/shade assembly and check for damage. Be sure to remove the
b
protective cardboard located on both sides of the treatment. Be sure
you have the right unit size for your window by holding the assembly
up to the door window. It is important to operate the treatment only
while it is upright. Be sure to read the instructions prior to beginning
actual installation.
For assistance with enclosed treatment installation or for additional
product information, call ODL customer service toll free at
1.866.ODL.4YOU (635-4968), or visit our website at www.odl.com.
Top Brackets
Soportes superiores
Supports supérieurs
Lengüeta paraelevary bajar
Tab-Open/Close (blind only)
Lengüeta paraabrir y cerrar
Languettepour ouvrir/fermer
Tab-Raise/Lower
Languettepour
soulever/abaisser
Spacer
Separador
Espaceur
LockClip
Sujetador
Patte verrouillable
Spacer
Separador
Espaceur
Spacer
Separador
Espaceur
LockClip
Sujetador
Patte verrouillable
LockClip
Sujetador
Patte verrouillable
HALFVIEW
VISTA PARCIAL
DEMIVUE
Top Brackets
Soportes superiores
Supports supérieurs
Tab-Raise/Lower
Lengüeta paraelevary bajar
Languettepour
soulever/abaisser
Tab-Open/Close (blind only)
Lengüeta paraabrir y cerrar
Languettepour ouvrir/fermer
Spacer
Separador
Espaceur
LockClip
Sujetador
Patte verrouillable
FULLVIEW
VISTA COMPLETA
FENÊTRE COMPLÈTE
1
DOES IT FIT?
Carefullyliftthetreatmentassembly andplace overthe window.
The frame shouldfit snugly overthe entire windowframe against the
door. Lookfor anythingthatwill preventa flushfitor keepthe treatment
fromfunctioning.Set theassembly down, standingitupright.
DOOR HARDWARE INTERFERENCE
If your door hardware is located close to your door glass frame,
you could encounter interference with the fit of your Enclosed
Treatment Unit. To avoid this interference simply remove the filler
strip located on that side of the Enclosed Treatment frame. This
will allow the escutcheon plate on your door hardware to slip
underneath the Enclosed Treatment frame. If the tabs on the
frame (used to hold the filler strip on the frame) are in the way,
you can simply clip them off with pliers.
If you have a lever door handle and the handle extends over your door glass / door glass frame, the Enclosed
Treatment unit may not fit. This interference issue is common with lever arm handles and window treatments.
In order to make the Enclosed Treatment unit fit you will either have to change your door knob so that it does
not extend over the door glass frame, or purchase a lever door handle extender.
1
Loading...