Ocean Optics FluoroVette User Manual

Materials:

Biocompatible Black Delrin body bonded with a
Non-leaching solvent acrylic adhesive
to a 50 micron UV transparent film.

Contained volume, 50 uL
Pathlength 0.75 mm
Dead Volume in channels: 1 uL for the inlet channel, 1 uL for outlet
channel

Solvent compatibility:
Ethanol ( up to 99.5%)

Isopropyl alcohol ( up to 91% in water)
Aqueous buffers with or without detergents

DO NOT FILL with Acetone or Aliphatic solvents such as Hexane. Wipe
the outside with lens tissue to avoid scratching the Optical Film.

Figure 1 Figure 2 FluoroVette

Shown below with the Adaptor assembly.

Inlet Outlet
Side Side

FluoroVetteTM Product Specifications

Connectors:
Hose barb connector (CFV-PUMP) is Polysulfone seated in acrylic

Pipette interface (CFV-PIP) is acrylic

FluoroVette Overall dimensions: 4.7 mm tall, 4.3 mm wide, and 1 mm thick.
Adaptor dimensions: 15 mm from base to the center of light path, 1 cm x 1 cm

outer dimension. Insert retaining ring with or without a lens to reduce light scatter
NOTE: The adaptor has a separate retaining ring to allow insertion of a plano­convex lens. Suggested lens; Edmund Optics: www.edmund optics.com

Light Source

LENS PCX 5 X 4.6 MGF2
COM

Directions for use:

The FluoroVette has an inlet sid e, which allows the flowcell to fill from the bottom to
minimize air bubble formation. The inlet side is shown on the left, the outlet side is
shown on the right in Figure 1.

NOTE Insert the FluoroVette
the light source of the fluorometer. Two notches at the top of the adaptor
indicate the light path as shown in Figure 2

Dia.

E.F.L.

5.0

TM

Type

4.6

PCX

TM

with Hose Barb Connections

FluoroVette

Comment

LAKN14

into the adaptor with the inlet side facing

Part #

NT32-403

Price

$19.00

TM

with Pipette Interface

ALine, Inc. PO Box 1068, Redondo Beach, CA 90278

830 Douglas Ave., Dunedin, FL 34698

Customer support: 877-707-8575 727-733-2447