Oasis P8AM Installation Manual

®

VERSAFILLER
Model PWSBF
Installation Instructions

The VersaFiller is an extension of the Aqua Pointe product line that mounts

directly above Versacooler I and II products. No additional electrical

connections are required.

If installed onto a refrigerated cooler, then chilled water can be dispensed
through the Versa Filler. Otherwise, room temperature water will be
dispensed.

The VersaFiller is shipped partially assembled.

When completed, the finished assembly will look like this:

OR

Section 1: Getting Started

What’s Included:

(Top cap)

VersaFiller Sports
Bottle Filler- (with

wrapper, alcove

and top cap
installed onto the
frame)

Drip tray

Gasket

Anti splash grate

Quick connect

tee fitting

38” of ¼ OD

plastic tubing

with 19” of

sponge tubing
insulation

Installation
instructions

Tools required:

 3/8 drill bit that will drill through SS top
 Electric drill
 Small tubing cutter for copper tube
 T15 torx driver with pin in head vandal tip

 T20 torx driver with pin in head vandal tip

Anti Splash

grate screws (2)

Snap bushing

 1/4 “ nut driver

 # 2 Phillips screw driver

Section 2: Rough In Drawing

Oasis PWSBF: Versacooler® II Models PAC, P8AC with VersaFiller

Section 2: Rough In Drawing

Oasis PWSBF: Versacooler® II Split Level Models with VersaFiller

* On split level models, the VersaFiller must be mounted
on the low unit in order to meet ADA guidelines.

Section 3: Installation

A: Drilling hole in the top for water line connection.

1. Disconnect power by UNPLUGGING unit. It might be necessary to
remove the front panel to get access to the power.

2. Turn OFF water supply to the unit. It might be necessary to remove the
front panel to access the water stop valve.

3. Place hole template onto cooler top so it is aligned with the left side of

unit and wall. SEE NEXT PAGE FOR TEMPLATE

4. Mark hole location

5. Remove top from unit.

Mark hole
location.

Template

6. Using a 3/8 drill bit, drill a hole through top.

7. Install snap bushing into hole to protect tubing from being cut.

Remove top from cooler by
removing six #15 torx head screws
on sides of top.

Drill

Install bushing

ALIGN THIS EDGE WITH LEFT EDGE OF COOLER TOP

Mark this center point on the
top. Remove the top from the
cooler. Then drill a 3/8 hole
through the top at the marked

3-1/4”
from
side

PLACE THIS EDGE AGAINST WALL

2-1/8”

from

back

center point.

USE THIS TEMPLATE TO MARK THE

HOLE LOCATION ON COOLER TOP